Find trusted local electricians in Cheltenham VIC

I am looking for a licensed plumber to investigate and fix a leak on my hot water system at our home in Cheltenham. System Details: * Unit: iStore 270L Hot Water Heat Pump (Model: PASHW015-270LD-FL02-R290) The Issue: There is water continuously leaking from the valve drain pipe on the side of the unit down onto the paving. I need someone to diagnose the cause of the constant leak and complete the necessary repairs. If you are available to assist, please let me know your availability and your estimated call-out or repair rates.

Need licensed to fix the light switch. I have already bought a replacement switch.

Downlight on the front porch are hanging loose. It's likely just the bracketing / fixtures and fittings because the elex connection to the lights is still working.

I would like to get 2 power points ( 1 in study and 1 in walk in robe) and get 3 ceiling fans installed.

Need 4 Power points run in a new workshop. Mezzanine level is exposed, so minimal drilling etc. 3 x 4 outlet GPO and 1 x 2 outlet. About 10 metres of conduit. 2 separate circuits with RGB etc. Plenty space in the fuse box. Happy with an apprentice etc.

Hi, I need a licensed electrician to supply and install a 32A single-phase outlet. Job Details: Cable Run: Approximately 20–25 meters from the main switchboard to the target outlet location. Socket: 32A outlet installation. Requirement: Must be a Licensed Electrician with active public liability insurance. Must provide a Certificate of Electrical Safety / Compliance Certificate upon completion. Supply all necessary materials (cable, 32A outlet, circuit breaker, circuit protection, conduit if needed). Please include your license status and whether materials are included in your quote when bidding. Flexible with timing for the right trade. Thanks!

Need an experienced commercial sparky to do some final fit off works, install a few downlight and sensors and also wire up an external led signs and a few internal ones. Probably a couple of days work in total. Looking for a good trade to continue all my electrical work moving forward. Budget is hourly.

1 power point moved slightly higher 2 cm in kitchen area Install 2 lights on wall hardwired with 1 x 2 gang switch Zetr 1 PowerPoint on back wall Zetr 1 PowerPoint removed on back wall down low 1 hardwired wall heather 150w 1 Zetr PowerPoint on back bottom wall for desk Switch replaced to 1 dimmer main light 1 switch for both bed lights Zetr

Looking for Electrician to help with an AC install Tommorow

I need one power point installed in the bedroom and another on the decking.

Hi I’m looking for qualified tradesmen to supply and install PowerPoint and antenna pint for tv

Change the switch button. It keeps on turning off

We have light, light, power on one phase. One of the light switch keeps tripping the main switch. This mostly powers the kitchen/pantry powerpoints. Also couple of other electrical items in the house. Need a power point reattached too which has fallen off the plaster wall

photo of the switchboard and property height of the building

Need a Power Point behind the TV and an aerial port and connection to roof aerial

Getting an Essato heat pump dryer delivered Thursday and will need someone to move it from the front porch to the laundry via trolley and set it up. I'd like to have the drainage hose draining into the laundry sink rather than the collection tray. Cheltenham.

Looking for an electrician who can meet at my property around 5 one afternoon this week to disconnect a push switch and terminate it and disconnect a light fitting, and the reconnect after I have fed it through a new piece of weatherboard.

Looking to swap out my old NC-6 controller for newer one, house has 2 zones ducted gas. Will attach photos for reference.

🔧 Bosch Serie 8 Dryer Service – Not Drying Properly + Noisy Drum (Cheltenham) Looking for an experienced appliance technician to service and inspect my Bosch Serie 8 heat pump dryer (self-cleaning condenser). ⚠️ Issue • Clothes are not drying as effectively as usual • Cycles are taking longer than normal • Drum is a bit noisy during operation suspect something caught between drum and spinning part like a shoe lace 🔍 What I need • Check and clean internal components (despite self-cleaning condenser this needs to be done as I suspect that’s the issue • Diagnose airflow, sensor, or heat pump issues (not likely this creating the issue) • Inspect drum rollers, bearings, and belt for noise (not likely this creating issue) 📍 Location Cheltenham, VIC 3192 📅 Timing Flexible, but sooner preferred 💬 Please include in your offer: • Your experience with Bosch Serie 8 / heat pump dryers • What’s included in your service • Call-out fee (if separate) • Availability ⭐ Preferred Looking for someone experienced with Bosch Serie 8 heat pump dryers (self-cleaning condenser) and familiar with common issues like cleaning the internal filter this is not a drum or bearing issue

I have two desk lamps with cords chewed off by our rabbit and a floor lamp with a defective switch needing repair.