Find experienced local carpenters in Prahran

I got my floors done and it ruined some skirting boards including the kitchen kickboard, I was going to do it myself but I don’t think I can make it look good. Looking for a professional at this task because I want it to look good. Red part needs replacing, blue park is kickboard as well as section under laminated cupboard I have a piece of wood to fill this area but needs completing. Also need metal bar put across below front door where the hallway carpet ends and my floor begins.

Scope of works - Replacement of hallway cupboard doors with MDF wood (current photos attached) - Installation of handles total = 6 (handles provided) - Installation of doors with hinges (hinges provided) - painting of doors with dulux vivid white Top cupboards x 3 doors Bottom cupboards x 3 doors Cupboard 1: Right hand side of hallway Top: 1100mm total width of cupboard space approx 660mm height Bottom Cupboards 1100 mm total width of cupboard space 1845mm height Cupboard 2: Top cupboard: 578mm width approx 526mm height approx Bottom cupboard 578mm width approx 1830mm height approx

I need someone with framing experience to build a bulkhead. I have the timber already.

I have two garage shelving units that need: (1) assembling, and (2) anchoring to a plasterboard wall in the garage. They are “Pinnacle 1830 x 1500 x 410mm 5 Tier Adjustable Shelving Unit” Assembly is with a rubber mallet only. Shelving height to match existing heights of a third shelving unit, that is already assembled. (See photo of garage) Should be a very quick task. Space will be cleared in advance

I am getting new countertops installed with an overflow and I need a handyman/carpenter to cut off the top of this hollow wooden backsplash. It’s not a difficult task but it will need to be neat so as not to splinter the remaining section. The cut needs to be where the yellow highlighter is in pic 1

Need you to attach a sheet of ply wood to cover wire cross rails. Can be screed into poles.

1) Make over built in wardrobe. Increase size of doors, new shelving, new doors 2)Make over small European laundry unit. Remove sink and install storage unit ***Quote will be needed $ provided is not an offer*** Seeking joiner who can provide materials and design

I would like builder gel nail extensions. Let me know if you can do that and come to my place in prahran to do so. Or let me know if u need me to come to you

I need someone to saw a bench we have, install new cabinets and a new sink.

Some part of cabinet (bench top) in the kitchen is damaged. I need to replace the bench top. The left side total cabinet size is 1.3 x 0.7 meters

Put up or build shelves in a store.

Cut stainless steel benchtop to fit sink. Benchtop is stainless steel. Measurements please refer to image.

Looking to build and install a triangle vocal booth . I have photos and measurements

General building/carpentry tasks: - secure shelving in cabnetry - Replace rotted decking (timber) - Remove floorboards at entrance and replace with doormatting - Oil/paint deck - Due date: Flexible

VARIOUS CARPENTRY JOBS, E.G., LAYING SOME FLOORBOARDS, HANGING DOORS, INSTALLING A SECOND HAND KITCHEN CABINETS, MAYBE BUILDING A SMALL SHED OUT OF STUD AND HEBEL PANELS. MATERIAL PROVIDED. HOURLY RATE PLEASE.

Create floating shelves from wood panel (already given).

I have four internal bifold doors in my hallway , laundry behind these doors . One has dropped and now is scratching the floorboards and is difficult to open . They probably need to be trimmed and sealed at the bottom . They would need to done by someone who would not chip the doors . The doors are 2.1 high , .6 wide . Thank you

Carpenter or experienced handy person needed before 4pm to 🅰️ install 4m picture rail and 🅱️ hang/rehang 2 single & 2 pairs of double doors . See photo for reference. Doors measure 230cm x 80cm

Build and install 5 x shelves and 2 x doors. Products/material to be used : - MDF - Painted or wrapped in white gloss (as per example picture and close up door picture) - Hinges x 4 (depending on door size) - 2 x thin size strips of MDF to hang the doors off Measurements - width 610mm - depth 300mm - Door size is pending on what you can provide and overall balance of the design Further details - As per drawing I want the door to hang lower than the bottom shelf, this is due to a robot vacuum sitting on the floor - I don't want the material to have exposed gaps, needs to be seamless - I don't want a carcass for the cabinet section due to the power points - Due date: Before Friday, 8 March 2024

Quote for carpentry work to be done