Find a professional lattice installation service in NSW

Build and install lattice, trim away current hedging in the way.

1. Wooden lattice with climber is falling down and needs removal 2. Side gate is also broken and needs replacing

Need to have some lattice screening replaced.

Attaching timber lattice to timber paling fence. Approximately 8m. Would suit someone with nail gun. Lattice already purchased

Need someone to build a lattice above a concrete block fence. 5.5 meters long x 40 cm high.

Thick, quality, charcoal shadesail fabric possibly custom made to be fixed around carport as privacy wall-screens down 2 sides and across one (road) end only (not house-end; this to be left untouched) to be off floor and possibly just below carport roof (you decide) with said outer road-end made into a 2-door swing-in fabric covered lightweight gate-frame, or lattice pieced gate-frame (or other lightweight method?) for rare brief single car access (carport used for seating area). My EasyShed flat roof 2.25mW by 0.78D by 1.82H (arriving soon) to be put up by you therein resting on thin pavers you recommend. Photo is not my single carport but is same, also as those seen in distance opposite. Note: all double carports are for two houses to share being divided down middle by two steel pole supports at either end ie the double carport seen in far distance is for two houses to share, as is mine. Only half of the double carport, including its shared middle section, is to be screened and gated. Carport measurements are: 450m/177" = the 2 down sides (each) and 300m/118" = road end going across (for your custom-made gate across bottom). The carport roof at outer edges (from ground) is 207m high, at interior 210m high. Suggested lattice (if not making fabric covered gate-frame or other method?) for double gate, is perhaps: Bunnings Jack Matrix charcoal plastic reeded diamond lattice; sizes include: 2410 x 1205 x 5mm 2410 x 1205 x 7mm 1800 x 1200 x 7mm 2400 x 600 x 9mm None of the carports are screened. Mine will be the first. As I have no frame of reference to guide me, any knowledgeable advice, economy saving tips, and helpful suggestions will be appreciated.

Replace the fence lattice around 10 meter on brushwood fence.

Need someone to extend my existing colourbond fence with lattice for more privacy

Hi there I need 12-14 of these lattice painted (can use a paint gun) I will supply the paint. Lattice Makers 1800 x 900mm Hardwood Slat Screen

My dog has destroyed the Lattice around our deck, it now all needs to be replaced, I would need you to measure and buy the materials needed as I have no idea what is needed to complete this job, budget includes purchasing the required materials which I am flexible on.

Dig a hole to install lattice in front of rainwater tank. Stakes to be put in ground to hold lattice in place. Three jasmine plants to be planted at the base of the lattice. Small border to be put around the jasmine plants and an echinacea plant that is already in the ground.

Existing brick wall, require a lattice privacy screen to extend the height.

I need to cover crawl space under the house Total Length is 26 meter with 12 brick piers. Height is 0.6 meter, using lattice from bunnings https://www.bunnings.com.au/lattice-makers-1800-x-900mm-hardwood-slat-screen_p3041193

2 panels of lattice fence have fallen from the top of our rear back wall. We need new panels to be installed to match existing. See photo

We have fence we did extension. 18 panels for 300m extension of lattice (standard fence width) 6 panels for 600m extension of lattice (not all standard width) - can provide measurement if required

Just want to get a lattice fixed on my colour bond fence

Supply and install 4 sheets of lattice, 2400 x 1200 to top of colour bond fence. Similar to existing on 3 panels (see photo)

Installed Colourbond fencing approx 22m, 1.8 mtrs high and 300mm latice on top. Also advise how much to take away Fencing. Also looking for an old retaining wall to be pulled down and replaced.

*** Tasker to bring a spray gun for this job - not interested in brush painting*** Spray paint fence (7m long, 2m high). One side of fence required - fence has been sanded + cleaned, no prep work required. Spray paint 3 x lattice (2.4m long, .900 high). Only required to paint one side of the lattice Request for two coats on fence and each lattice. Also to be very mindful and careful with the magnolias in the garden as they have just been planted. Paint will be supplied (using Dulux weather-shield). Drop sheets and plastic covers for plants also supplied.

We need to enclose underneath of one side of the house with lattice. Please see photos of area to be enclosed and then photos of what we would like (to match the back of our house). The existing lattice is not fixed and can be removed to allow access to underneath the house. Happy for you to look at the house first if need be and to take measurements. Need completed on a Mon, Tues or Wednesday. Thanks