Find an experienced handyman in Surrey Hills

I’m looking for a plasterer who is experienced with ornate/period detailing to: Remove existing basic/standard 55mm coving Install the Victorian 1H cornice Install 2x ceiling roses Estimates 40 lineal metres

Picture hanging and clock

Garage door will not close. Gets 1/3 of the way down, beeps then opens up again. It cannot be locked. We manually close it, place a pot plant to hold the door in the down position. Looking for someone to repair it.

Have towel rail ,and toilet holder and shelf in shower loose, on tiled wall.fix and make sure all good. , also put some hooks under stairs to hang bags etc. hooks supplied,

Replace skirting board in bedroom and re hang door opening the opposite way

Install EasyShed Off The Wall model EW-D3808, 3.75m wide × 0.78m deep × approx. 1.97m high. https://easyshed.com.au/products/otw-garden-shed-3-75m-w-x-0-78m-d-classic Shed is flat packed and ready to assemble. It will be installed along the side of the house on the existing concrete area shown in photo. Need someone experienced with EasyShed installation to: – Fully assemble shed – Position correctly against/alongside house – Secure shed properly to existing concrete – Supply/use appropriate concrete fixings – Own tools required

Hi roller shutters stopped working. Upon inspection it looks as though the chain has been damaged. Can someone look at it?

Install New Marble Entry Pull Handle on Front Door I need a professional/experienced handyman or installer to install a new Lo & Co Ora Entry Pull in Carrara Marble on my main front/entry door. I previously had the same marble handle already installed in this exact location, so the door already has the existing mounting position/holes. One side of the old handle came loose/off. I tried to secure it again with glue, but unfortunately a small section of the marble broke, so I have purchased a completely new replacement handle. What I need: * Remove the old/damaged marble handle carefully. * Clean/remove any remaining glue or residue as required. * Install the new Ora Carrara Marble entry pull in the same position. * Check the existing holes/fixings and make sure everything is properly aligned. * Ensure the new handle sits flush, straight and secure without putting unnecessary pressure on the marble. * Please take extra care as this is natural marble and can crack if installed incorrectly. Important: I have the manufacturer’s installation guide and will provide it to the installer. The guide specifically says the screws must pass freely through the door, the handle must be correctly aligned, and the final tightening must be done by hand only — no power drill/impact driver for tightening the marble handle. Lo & Co also recommends using a professional installer for the best result. This is only one handle on my main front door. I already have the brand-new replacement handle ready to be installed. Looking for someone experienced with door hardware / premium handles / marble or delicate fittings who can install it properly and securely.

Need an experienced carpenter to supply and replace the front and back lattice of the carport with vertical slates. Dimensions: Front lattice: 640mm(h)* 2880mm(w) Back lattice: 640mm(h)* 3330mm(w)

Replace front and back lattice with vertical slates. Supply and install. You can quote on labor, material cost will be reimbursed. Update: Dimensions: Front lattice: 640mm(h)* 2880mm(w) Back lattice: 640mm(h)* 3330mm(w)

I need someone to install my heat pump dryer in my apartment and connect the drain hose for continuous drainage. The job includes: • Position the dryer in the laundry. • Connect the drain hose to the existing laundry drain (if compatible). • Ensure there are no leaks and test that everything is working correctly. This is an apartment with lift access. Please bring any small fittings or hose clamps if required. If any additional plumbing work is needed beyond a standard installation, please let me know before proceeding.

Install an aluminium door vent onto wooden door. I can source from Bunnings.

Install of washer / dryer including tapes and waste connection

Supply and install barn door

We have a few jobs that for a handy man/carpenter. 1. Broken door handle-door won’t open 2. Front Door jamming 3. Internal door not closing as latch not fixing

A kitchen drawer is stuck and will not open. Not sure where it is stuck

Purchased a new Hills Everyday 37 Rotary Clothesline (refer to image) which needs to be installed to replace existing clothes line which needs to be removed and disposed of (refer image of existing)

Install mesh guard on 2 X chimney to prevent possums The chimneys are accessible from color bond hip roof (photo taken from outside slate face )

Need patch repair done remove vent and patch had water sitting intop Ful patch and paint

I need a render for fix the damage