Find an experienced handyman in Point Cook

Description: Looking for an experienced sliding door repair specialist to inspect and repair a sliding glass door. One of the sliding doors has recently become very hard to open and close. The other door is operating normally. What I need: Inspect sliding door and identify the cause. Check rollers, track and alignment. Adjust rollers if possible. Replace rollers if required. Ensure door slides smoothly after repair. Advise if any track repairs are needed. Additional Information: Door is a timber-framed sliding glass door. Issue appeared recently and has progressively become harder to open and close. Photos attached. Location: Melbourne Please provide: Your experience with sliding door repairs. Estimated cost for inspection and labour. Cost of replacement rollers if required. Earliest availability. Note: Looking for repair first. Only interested in replacement if repair is not economical.

Task: Replace Kitchen Sink Mixer Tap The existing kitchen sink mixer tap is dripping and needs to be replaced. A new replacement tap has already been purchased and is available on site. Scope of work: * Remove the existing kitchen sink tap. * Install the new tap supplied by owner. * Check all connections for leaks. * Ensure the tap is operating correctly and hot/cold water functions as expected. Please provide a quote for labour only. Photos of the existing tap and replacement tap are attached.

Install 4 primaacoustic ceiling clouds Specs are Dimensions: 24” x 48” x 1.5" (610 x 1219 x 38mm) Core Material: Formed, semi-rigid inorganic glass fibers Density: 6.0 lbs pcf (96 kg/m3) Weight: 8.3 lbs (3.8 kg) Facing: Acoustically transparent polyester or paintable glass wool tissue micromesh sealed with latex paint Backing: Sealed with acoustically transparent micromesh dge Treatment: Sealed and hardened with resin Recycled Content: Up to 40%

Hey guys - I’m looking for a handyman who can help me get the wall mirror fitted bit higher on the wall. You can see me in the photo and its current spot that I managed to hang. All I need is to get it moved bit higher and should be on the timber.

I have a 4 awning wires that comes out from motor and I need to connect them to main Power supply . I have a remote which means that there must be a continuous power supply to it. What i have read is that it says that it needs to connect to a junction box. Its a 4 wire cable. Black for extend,brown for retract , blue as in neutral and yellow/green as earth wires. These are the wires coming out of the motor

SUPPLY AND INSTALL door to ensuite. Measurements stud to stud: 2290 X 960. Width 205. It's internal door with privacy locks.

Anchor or put these wardrobes already built on to the wall. Need to keep it little bit higher above the ground. These are freestanding at the moment

Need to render the brick portion of the house facade from the front

Task 1 – Curtain Rod Middle Bracket Repair & Remount I have a black curtain rod in my home theatre room where the centre support bracket has pulled out of the drywall, taking some of the wall compound/paper with it. I need someone to fix this properly so it holds heavy blackout/theatre curtains securely. Photos of the damage are attached. What needs to be done: • Remove the loose/damaged bracket cleanly • Patch and repair the damaged drywall area so it’s smooth and paint-ready (ideally by cutting out the damaged section, backing it with a timber noggin behind the plaster, then patching, sanding, and finishing) • Remount the existing bracket using heavy-duty wall anchors (into a stud or with solid backing) • Ensure the curtain rod sits level and is strong enough to hold heavy theatre curtains without pulling out again I’m also open to a quick-fix option (preferred way) if it can be done cleanly and strongly: remove the damaged anchor screws, fill the old holes, and install new heavy-duty anchors in slightly repositioned locations — no full wall patch needed if the result is solid. Please let me know in your quote which approach you’d take. Task2 I also have a small chrome wall-mounted holder (photo attached) that has come off the wall. The mounting plate has two screw holes. I just need someone to screw it back securely into the wall using appropriate anchors. Suburb- Point Cook Thanks

I need help lifting a motorized awning your job help me measure and helping installing the awning. I will provide all the tools

Put 3 toilet holders and two hand shower holders and install a cloth hanging rail. You will need your own glue and large screws for the cloth hanging rail.

Need to hang an artwork, painting and a round mirror on the wall professionally as the artwork is quite heavy.

Mirror mounting in my hallway which I got from Kmart at Tamar Avenue Point Cook

Dry wall repair and paint.

Our front doorknob has fallen off and needs replacing. At the moment we are unable to open the front door.

Front door is dropped and hard to open. Looking to fix it.

I need someone to repair a hole in the wall and repaint it. There are also some areas where the paint has peeled off due to picture hangings that need to be fixed. Thank you

I have a new door I need installed. It requires door cut outs, for door handle and hinges.

Replace old kitchen sink water tap

Garage door setting fix. The garage door stops a feet before closing. Needs to align the motor setting to make it close.