Find an experienced handyman in Perth Central

1. Move 75inch tv from Office in East Perth 2. 3km to Apartment in Perth CBD (no stairs) all lift. 3. Install Tv wall mount.

I need help from grouting specialist or a tiler to check water proofing and fix the wall where plaster is coming off because of rain or moisture. I will need a warranty for this repair also.

Sink plugs have come off. Need fixing. Double sink

Need a hole in a door fixed and then painted same colour

I have to take my tv down at my business in Inglewood and bring it to new location in Northbridge. Mount it to wall there. Drill a rack there to wall also.

Curtain brackets need to be fixed and some light replacement

General Maintenance / Handyman works at 3 Sheike stores around Perth. Hoping for one person/contractor to complete the works at each store preferably (each located within 25 minutes of each other) , otherwise can be split. Works required: Sheike Carousel: - POS draw maintenance - lots of items to be fixed on this unit– Image attached - Back Room Light switch: reports of crackling sound coming from when we turn the switch on and off (previously had it replaced for the same issue) Sheike Morley: Repair tracks in walls – image attached Sheike Whitford: Image attached - Secure loose front tile - Re attached fitting room bar - Replace fitting room curtain rail Please provide a quote for the works, and message me with any questions. See images attached of the works below

I need a plasterer to fix up two walls where 1) we have had a sink removed and 2) an electrical extension chased along a wall. The job needs to be completed to a finish ready to paint (primer) Where the sink has been removed the top hole is approximately 60 x 15 cm - although a larger area will need to be fixed where plaster baird is damaged. The bottom hole is approximately 25 x 15 cm

Large oversized kedar edge banner

wooden window frame is damaged, so the window is not closing properly. the latches are also broken and the hinges are very stiff. would like the window repaired but would be open to having it replaced if necessary

Hi can I get a quote please! i need to have a hole in a door fixed up.

Supply and install 2 powder coated classic cream meter box doors. 1 for electric meter and 1 for gas meter with viewing window on both doors and locks on both doors.

Looking for assistance to fix the bolt that secures the door to the doorframe, as well as a few other minor issues with these doors, see below. Price of $750 assumes that this includes airtasker fees, but is negotiable especially if all four items below are covered. Issue 1 (priority): - Double doors to the balcony in an apartment, one door opens with the handle, the other doors has two bolts securing the door to the top of the door frame and bottom of door frame. - There are two levers in the door to detach these two bolts. The bottom lever works fine to move the bottom bolt, but the top lever moves up and down while the top bolt stays locked in place, so it looks like the lever is detached from the bolt. - Looking for help to fix this problem, so that I can open and close both doors to the balcony. Issue 2: - I have a second set of identical doors on the balcony. - For the second set of doors, the top bolt appears to be jammed - that is, I cannot move the lever to pull the bolt out. - The bottom bolt works fine. Issue 3: - For both sets of doors, the sealant between the glass and aluminium has gaps in it, which creates a whistling sound sometimes from the wind. Issue 4: These doors might be about 25 years old, so I was also hoping that you can take a general look at other aspects of the doors while you are here, to prevent future problems. Additional info: - Doors are about 2.7M tall - Top lever is ~600mm from the top of the door and bottom lever is ~300mm from bottom of the door Photos below as follows: 01. Top bolt - disconnected from lever 02. Lever for top bolt - disconnected (Issue 1) 03. Top lever - photo from further away 04. Top lever for second door - jammed (Issue 2) 05. Middle of door (door handle)

My flyscreen door on my balcony has come off its tracks & I think it needs to be replaced as even when I get it back onto the tracks, it just comes off again. Will probably need someone to come out, inspect & measure the door, then source & install it. The price I’ve suggested wouldn’t include the cost of the door

We have 3 to 4 areas that need to be blocked off by baby gates to keep our baby from the stairs and the kitchen. Would prefer someone who has experience with this. The gates we have are pressure mountable. I currently have 4 gates and about 2 metres in extensions. Might also need a trip to Bunnings as needed. I can return the items I have already purchased if needed. I can be available on the day to go along to Bunnings if needed.

Hello, I am chasing a bifold door with installation that suits the following dimensions of the existing door. I have attached a few images for your help. As you can see, the door is currently blocking a lot of the bathroom, so I am hoping that once folded in half on the left side, if you are facing the entrance, this wall before the towel rack has a clearance of 480mm and lands on the side with the towel rack. If my maths is correct, it should give 720mm/2 = 360mm, so it should fit in the space? Existing bathroom door: 720mm width Height - 2015mm on one end, middle moves to 2023mm, then back to 2017mm (think there was some door shaving when it was initially installed). 35mm depth

We need a reliable and experienced person to dismantle and reinstall 15 workstations over two days for our client. This task does not involve transporting any equipment, removalists will handle the actual move. Day 1 (14/04) • Unscrew 2 x monitor arms per workstation from the desks (monitors can remain attached to the arms). • Wrap each monitor+arm setup in bubble wrap for safe transport (bubble wrap provided). • Bundle and label peripherals Day 2 (15/04) • Reattach monitor arms to desks and position monitors appropriately. • Reconnect docks, keyboards, mice, and headsets. • Basic cable tidying (no detailed cable management required). • Ensure all workstations are set up as they were originally. Offices are located in the Perth CBD

I need a handyman to change a shower set (remove the old one and install the new one shown in photo), fix a door handle that has become loose (see photo), and lower the mattress in a cot from baby height to toddler height.

Door knob is loosen up. I have to make it tight. There are two doors.

I am in an apartment in West Perth. Behind a glass sliding door to access the balcony, I have a retractable flyscreen. It sits on a track that you can pull and retract back and it runs parallel to the sliding glass doors. The flyscreen is about 3 metres in length and 2 metres in height. What has happened is that a small part of the bottom portion of the flyscreen mesh has detached and come off the flyscreen frame which is causing difficulty pulling and retracting the flyscreen. The mesh needs to be repaired (or replaced entirely). Otherwise, the mechanics for the flyscreen frame itself appear fine. Repairs on site would be preferable. Otherwise pick up is fine. Generally available during the week and weekends.