Find an experienced handyman in Box Hill VIC

Fix silicone in showers and around sink, paint and repair deck paint touch ups outside

I need someone to assemble a easyshed 2m x 1m metal shed. sorry I forget to add the discount code , is this apply ? Here's your exclusive Airtasker discount for your first Easyshed task Use code R9QQND7X to get $30 off your Easyshed assembly task* *Easyshed customers can get $30 off their next task. $200 minimum task value applies (excl fees). Offer and promotional code valid until 31/12/2026 11:59 AEST. One per customer. Redeem your promotional code by entering the unique voucher code at the time you assign your task and make payment. Codes cannot be used in conjunction with other promotions and are not refundable, exchangeable or redeemable for cash. For full Terms and Conditions, please read www.go.airtasker.com/easyshed

I have a leak under my kitchen sink (see pic where seal is broken). Require a plumber to fix this.

one bedside table lamp has old electric cabling and needs to be redone.

Need to repair tactile on footpath

Sink has dropped from vanity table in bathroom. Needs prior experience on similar issues. All tools and consumables to be provided by you

Need a bathroom redone in a old home

Existing Roller shutter, unable to open. Suspect it is electrical, but not sure. If you can make budget quote, I want to change all my roller shutter to electric.

Looking for an experienced PPF installer to help out our shop. Great pay, shoot me a message.

I have a tilt garage door (“Tiltador” on the garage door handle). The metal bar holding the spring was snapped and now the garage door cannot be opened.

My bathroom door is a sliding door, and when closed fully, there is a gap at the bottom (see photos), presumably from being unaligned/being tilted. Not sure if it's a roller issue perhaps. I have the same issue with the downstairs sliding door (see photos) that opens to the backyard. It doesn't seem to fully close, leaving a gap at the bottom. If I lift it, I can close it fully, but it drops down again with the gap if I let go. I can't see anywhere to adjust the height of the door, so was looking for someone else to take a look. Budget negotiable

There’s mould discolouring the silicone near the sink. Remove old silicone carefully and replace with new white silicone in a seamless manner. The area involved measures 60 cm. Must bring silicone and all blades/scrapers needed and clean up after completion. Thanks.

I need someone to come and install two new washers in my kitchen sink

Install heated towel rack and connect to internal wiring.

Garage Door Repair – Pulley Replacement (Sectional Door) Looking for someone experienced with garage doors to fix a sectional garage door. Issue: One side pulley/roller has failed (bolt broken) Cable has come off due to pulley failure Scope: Replace faulty pulley/roller Reinstall and tension cable Balance door and check operation Ensure smooth and safe opening/closing Note: Door panel slightly bent on one side — OK if not perfect, just want it operating safely Photos attached. Please quote including parts and labour.

Supply and install 2 new cement sheets on 2 brick walls (in common areas of a block of six units) to cover 2 old windows. Paint new cement sheet with 2 coats of paint to match existing color of brick walls

Replace fly screen and fix a floor board

Need a reliable handyman to replace my broken letterbox with a new one as shown from Bunnings or similar Tasks: purchase the letterbox and post from Bunnings ( there is one nearby) Remove the old broken letterbox. Install the new one securely . Take photos to proof job completion

I have already bought the door handle just need someone to put them on the door

Looking for an experienced appliance technician to perform a maintenance check and clean on my 2-in-1 washer dryer (approx. 1 year old). The job includes: • Full maintenance inspection (including checking it's installed correctly — hoses, drainage, levelling, etc.) • Internal and external clean (drum, filters, door seal, detergent drawer) • Flag any issues or anything to watch out for The machine is in good working condition — just want to make sure everything is in order and keep it running well long-term. Please only bid if you have experience with washer dryers or white goods appliances. Happy to answer any questions!