Find a professional gyprocker contractor in QLD

From previous page hole in gyprock low near floor size watermelon

Need a Gyprocker to repair this hole in picture.

2 x 55” Samsung TV’s plus 1 x 65” TV, looking for assistance to install and hang on wall mounts provided. Need to provide Gyprock anchors, or I can buy if requested. Walls are flat and clear open space. I can provide power tools.

Need a 3.5 inch roughly diameter hole patched and fixed. No paint needed, I'll take care of the match and pass.

Hi, I’m looking for someone experienced with gyprock/drywall repairs to fix and properly smooth a small patched area on the wall. A temporary patch has already been done, but it’s still visible and uneven. I need it feathered out properly, sanded smooth and blended so it’s inspection-ready for end of lease. Must be completed before Saturday. Please bring all tools and materials. Looking for a neat, professional finish so it doesn’t stand out. Located in Bokarina. Thanks!

This is a brand new build and I require a days assistance onsite to help hanging gyprock ceiling sheets to a stairwell and a garage. I will also need a hand moving about 30 timber planks from the garage and relocate elsewhere onsite to allow room to work in the garage

Gyprock has already been removed from ceiling and on is on the floor I need someone to collect gyprock waste and remove remaining insulation

I need to close the gypsum board walls.

Previously had water damage to the window seal. Need this to be repaired and set (I can sand and paint it myself no problem)

Gyprock 2 walls include battening , for paint ready . Area # 1- 2.2x 2.4m #2 - 1.5 x 2.4m

Hi, I’m looking for someone experienced with plastering/gyprock repairs to patch two wall holes where a reverse cycle air conditioner unit used to be. Details: Hole 1: approx. 70cm x 27cm Hole 2: approx. 10cm x 10cm I have gyprock available to use. What I need done: Patch and secure gyprock Set and smooth finish ready for painting (Painting not required unless you can include it as an option) Other info: Ideally looking for a neat, clean finish Please bring your own tools and materials (apart from gyprock) Thanks! Please let me know your availability and your quote.

Need to install gyprock and plastering (tap and coating) for laundry room. measurements attached and materials provided

I have just purchased 3 x curtain rods. I'm going to remove the old retractable blinds and need someone to measure 250cm from floor, brackets over window to hang new curtain.

Renovating a small bathroom and getting it ripped out. Will need to replace 7m2 of villaboard/gyprock sheet in the shower. Also would need to cut out a niche. Two sides of the shower wall is villaboard and third is gyprock. Small patches of gyprock in the skirting. Feel free to quote or we can setup a time for you to stop by

The job is for fixing Gyprock holes, paint rips and scuffs for and end of lease bond clean. Experienced plasterer preffered as end result is important for bond release. - had 3 wall mounted TV's - paint rips from 3m tabs as painters never used base coat. - I've repaired crudely a couple already but used gloss, now have he right paint. - a couple of holes from moving and just general clumsiness I don't believe this to be a big job and an experienced plasterer would no doubt knock this over unfortunately although I was aiming to do this myself we are becoming short on time and require the extra help. Look forward to your offers.

Gyprock wall patch needs section of wall replaced following a poor repair. 1000mm wide x 750mm high to patch $200 includes labour and materials but has to be done tomorrow 10- 2pm Brisbane cbd.

Repair ceiling gyprock and paint

I have 2 areas in my house were gyprock have been cut out for a water leak we had that need to be filled with gyprock and patched again

Water leak caused partial ceiling collapse. Leak fixed, hole remains. Approximately 2500 x 700, straight set. Friday would be good.

Bring tools to drill acrylic reception sign behind the reception desk. Centred on the gyprock wall behind the desk. Wont take long at all.