Find an experienced gas fitter in Melbourne

The piezo ignition ignites the pilot light, which then ignites the gas burner, but the burner cuts out a second or two later. This seems to indicate a dirty or faulty thermocouple or a weak or misaligned pilot flame.

New Smeg appliances need instalation and old appliances removed and disposed of. I need a photocopy of your Electrical Licience and a Safety Certificare supplied upon compleation.

Need to replace pilot on wok burner

Remove Vulcan gas heater I would love if I could please be quoted the cost

The stove brand is B&S. There are 2 burners is not working and need to be fixed.

Need fitted kitchen altered so as to be able to fit bigger gas stove

One of the burners is not working. I am guessing it's the spark issue, as the other three are working and there is gas coming out from the non-working one. Its a Meile brand. please submit your offer

Pick up and dispose of gas heater and old fan.

We smell a.lot of gas from the Indoor Rheem Hot water unit. Needs to be investigated for a leak.

After some assistance to have a gas oven disconnected before the electric oven is put in. Oven is free standing gas - if you can take it as well, that’s great. Not essential though!

I have had some kitchen renos and need. Gas stove reconnected. Also need new sink properly installed. Its in place but tap isnt secure and needs to be connected to water and drain etc.

Gas leak has been diagnosed by gas supply co but cannot fix because they told us its not on the supply side so we have to get our own plumber. They have turned off the gas at the meter so it is safe for now, but we can't use any gas appliances =(

I’m in Moonee Ponds and I need a new oven/stove connected and the old one disposed of by a qualified electrician.

We have a Vulcan Gas Heater and it does not seem to work when turning it on inside We believe the pilot might need to be lighted, but we are unsure on how to do this. The device does have an operating instruction sheet on it (image attached) Looking for someone who can come have a look and guide us on how to operate it Model: Vulcan C - X Gas Furnace 902

The cooktop is a 4 burner Smeg - only one is not sparking and cannot be used. The task is for the repair of the defective burner. Flexible with the time and date but I need it done sooner than later. Melbourne CBD close to Queen Victoria Market.

Need a qualified plumber and electrician to a. access and cut off gas and power supply to an old heater Job does not include removal of heater

Gas was cut yesterday and now hydronic heating unit needs restarting. Gas supply restored.

I have an electric 4 burner stove top and needs to be replaced with 4 burner gas top. Gas line is available underneath. Plumber will need to get gas fitting pipe approx 1.5 mtrs to connect the burner to gas outlet. The cut out is fit to size and the gas burner should slot it (already checked)

Need a plumber to cut a gas pipe and cap it off inside the brickwork so that the wall can be bricked up. The pipe is from an old gas heater that has been disconnected, but the pipe was capped outside the house.

Gas water heater - Rheen model 850330 Issue - hot water stopped coming. Checked unit and found continuous water dripping on the burner .. pilot light worked but didn’t stay on due to leaking water .. leak only stops when cold water turned off. Need to check the issue and quote for repairs