Find a professional cement sheeting contractor in VIC

New town houses are going up at the rear of our house. I want to build a soundproofed enclosure for our 3 x air conditioners that are next to the new neighbours small 2m back yard. I would like 2 x 'air gapped' 100mm gap of cement sheeting built. So it is (not touching). Then install soundproofing insulation bats in between the cement sheets or stuck to one side. (i have the Bradford sound proofing bats already to use). I also have the styrofoam insulation sheets that are in the photos that can be attached too. So the person who builds it will also have to build the air gapped cement sheets on the ceiling of the enclosure and then put back the corrugated steel roof. ( I already have heaps of corrugated steel for roof). I would like the person to pull down all the current materials. So they can rebuild the enclosure. There is wooden framing already there. Although I want an additional wooden frame built to ensure its not touching. I would like it to be very well gap filled & caulked so all edges are sound proofed. See the drawing provided. cheers. I will reimburse receipts in cash for materials purchased for the job.

Install Fibre Cement Sheets & Decorative Timber Frame – Werribee I'm looking for an experienced carpenter or handyman to complete an exterior wall project at my house in Werribee. Please refer to the attached photos for the existing wall and the area to be completed. I have also attached I bit of reference that's expected. Scope of work: - Remove and dispose of the existing corrugated metal sheets. - Check existing frame work, strengthen it and change if needed. - Supply and install 3 x 2.4m fibre cement sheets on one side and 3 x 2.4m fibre cement sheets on the other side. - Install the sheets neatly with the appropriate capping and ensure a clean, professional finish. - Build a decorative timber frame in front of the fibre cement sheets using smooth, paint-grade timber (such as dressed/primed timber), suitable for painting and with a clean, finished appearance. The frame should be approximately 500mm high from the ground. - Install heavy-duty wire mesh (re bar is fine) within the centre of the timber frame for climbing plants. - Install a decorative timber feature on the gable end, as shown in the attached photos. Requirements: - Supply all labour and materials. - Remove and dispose of the existing corrugated metal sheets. - Take away all waste and rubbish, leaving the site completely clean. - Finish all corners and edges neatly with a high-quality, professional finish. Budget: Including all labour, materials, disposal, and site clean-up.

Install and Repair Plaster and Put Cement Sheeting over

External painting of newly installed cement sheet cladding. Some trims around windows too. Will provide paint. You will need to provide rollers, brushes. There are ladders on site you can use. Please provide your day rate (8 hours)

Patch & repaint damaged cement sheet — shopfront pillar Small repair to a damaged section of cement sheet cladding on an external shopfront pillar (hand-sized hole — see photos). Looking for someone who'll take the time to do it properly. The job: Cut out the damaged section and patch with matching cement sheet Flush the joins so the patch sits flat Colour-match the existing dark textured paint (sample or scanner match) Repaint so the repair isn't noticeable Requirements: ABN and tax invoice on completion Photo of finished work Address and access details provided once selected. Photos attached.

replace weatherboard with metrix cement sheet

Rotary hose unit attached to wall

I have a rotary hose unit installed onto a cement sheeting wall in my courtyard.

Cut out the broken sheet and replace with new

Need a piece of cement sheet cut to 800 * 1100. Ideally 6mm or 9mm I’ll pick up from Geelong / Torquay today or Tuesday. I don’t have access to tools. To be used under stone fire place hearth.

I have a small laundry/powder room being renovated and need cement sheets replaced on the bottom half of the room. The room dimensions are approximately 1.8m long x 1.8m wide x 1.2m high. Looking for a quote on how much this might cost.

I need someone experienced to remove a sheet of 1400x2700 plasterboard and replace with 10mm fibre cement sheet.

I can supply some cement sheeting just if someone could install it to my fencing approximately 50m worth the sheets all come in 1.2m lengths

Covering a bare framing approx 11m x 3m wall and skirting (tradesman to supply all materials). I’m currently overseas, but job could be commenced from 17 May.

Looking for someone experienced with bathroom renovations to finish preparing a small bathroom for waterproofing. Bathroom demolition and plumbing rough-ins are complete. Scope of work: • Patch and support floor opening around bathtub waste pipe • Install 6mm cement sheet to bathroom floor • Cut cement sheet correctly around existing shower puddle flange • Fix sheets securely ready for waterproofing Walls are plasterboard and will be waterproofed directly. Must have experience installing cement sheet in bathrooms ready for waterproofing. Location: Cranbourne West Materials supplied: 6mm cement sheets & nails Photos attached.

Need assistance with installing cement sheet and plasterboard into a bathroom

I want to remove old timber cladding below front and back windows. It is around 4m x 1m high at the front and around 6m and .6m at the back. It is the second floor, but there is a flat roof in front of the front of the house and there is a 600mm box gutter at the back of the house. Pics added 1st is the front and the rest are the back. I want to insulate and make airtight the area, I was hoping for spray foam. Then I want to add cement sheets, can just be stanard cement sheet stopped up.

Supply and install 2 new cement sheets on 2 brick walls (in common areas of a block of six units) to cover 2 old windows. Paint new cement sheet with 2 coats of paint to match existing color of brick walls

I need a handyman to remove a single damaged Colorbond sheet in my back fence and install the replacement one. ​I have already purchased the replacement sheet (Standard 1.8m). ​ The frame and rails are in good condition; only the infill sheet needs swapping out. ​The task involves removing the top rail, sliding out the buckled sheet, and installing the new one. I have a drill but you may need your own tools

I have straightened the walls just need someone to hang cement sheets on walls and plaster on ceiling of bathroom reno