Find experienced local carpenters in St Albans VIC

As pictured, need bottom shelf moved up a few inches upwards, along with the cupboard hinges. This is to fit new fridge, no parts needed. Just retrofit existing cupboards higher up, as to make room for new fridge.

I need a chippie to knock up the timber framing for a curtain pelmet ready for plaster. You can see my rough drawings. I’ll supply timber

Rebuild the bathroom cabinet and redo the plumbing. Materials included in the quote

1. A small laundry cabinet 2. In kitchen adding a dishwasher to the right side of the sink by replacing the existing cabinet door, and installation of a new hood and stove.(see attached photos - before and after) * Flexible weekday evenings and all day on weekends.

Basic hinges to be rectified or if required new from Bunnings to be purchased to replace. But mainly work has to be done properly as the cabinets must be easily to be opened and closed.

I need a few neat circular holes drilled into a display cabinet to allow electrical wires to pass through and keep the area tidy. The job requires clean, precise cuts without damaging the cabinet. All tools and experience required. • Cabinet is MDF / laminate • Flexible timing, preferably this week • Please bring your own tools

Hi,I’m looking for a custom sturdy frame but light weight sliding door on track. Please see images attached for the space and examples Maybe no fluted glass but polycarbonate sheet Aprox H 2.5m

I have a entry hallway cladding system and just need an expert cabinet maker to install. I can assist but I’m not a cabinet maker. Have some drawings to go off. Some parts are tricky it’s worth coming by and having a look.

I have put together the Ikea cabinets, upper and lower as well as the drawers myself but I now need help with placing it in the kitchen. I need help making sure the cabinet are installed evenly, leveled and the rails are attached correctly. I also need help installing the rangehood, gas stove and dishwasher if possible. I basically need help getting the kitchen ready so that we can install the countertop stone. I have attach the current photos, the model photos as well as the cabinets we would like to put in. Please note the plaster wall will be repaired prior to installation.

Small built in walk in wardrobe to be supplied and fitted

Install ENHET ikea cupboard in laundry. Exterior wall - may need to be secured into brick

Have an arch doorway which needs to be converted to a square doorway. Need some carpentry and plaster work done. No need to paint though.

Wall partition and slide door

Cut 35mm by 70mm woid and brace ply to size. Make door frame cut fir doublr cylinder.

I have all the wood purchased already. I need someone with the expertise to build me a shed. No bigger than 10square meters. You just need to turn up with your tools and get the job done

Clean, strip, and stain an antique table. Wood is Victorian Ash and it is 99 cm wide, 60 cm deep, and 77 cm high.

Hello, I need a custom internal door (sliding/bifold/trifold, anything) Requirement: supply and install, light materials, lockable. Carpeted so floor track is not recommended. Approximately 3m height x 1.5 wide Floor plan is attached. Other images are example of the door only

Fabrication of 2800 x 3000mm wooden frame with stand, painted finish.

To remove some carpet stain in three bedrooms. No carpet cleaning needed, only need stain removal.

i have stain on wall and wardrobe i need to get ride of them by painting g it off