Find experienced local carpenters in South Perth

The threaded inserts in the wooden center legs of the bed have stripped due to the soft wood, preventing the legs from being re-secured to the frame. Fixing options are putting threaded inserts or small corner braces.

I would like a wooden baby gate making for the top of our stairs to stop out 2 year old trying to get down to the garage. Photo attached of the type of gate.

Before putting the cabinet doors back on, the doors need to be cut from the bottom by about 5-10 cms so that the range hood’s front section can open up Also need to tighten up the adjacent doors to level the gap between each cabinet.

We have 2 Ikea Cabinets which we need trimming down to fit under a desk by about 2cm.

Door to Sauna in appartment block has panel fallen off through expansion and age. Need the panel attached with beading and nails

Shelf to be put on an inside wall, but with screw holes not showing, almost like a floating shelf.

Build range hood box with a door - 900x840x300 Cut doos to size 700x800 - 3 required Check size

Building a feature wall for the living room for the fireplace. Needed to build a timber box approximately 2m wide, 3m tall, 60cm deed - Due date: Flexible

We are a Dental Lab and have two suction units to be installed into our desks. Images attached. Desks need to be unscrewed and then The units placed. Possibly(not definitely) may need to cut a bit of the desk down. Also drawer runners to be installed in two drawers. - Due date: Needs to be done on Wednesday, 22 November 2023

We need draws made for this space. Happy for you to come in and quote. We are wanting 5 draws. Approx 350x700 - Due date: Flexible

Carpenter required, or anyone else who has all tools to build a fireplace box - Due date: Flexible

Cabinet maker/carpenter to design and make a customised bar unit. Initial fee is for measure and quote. - Due date: Before Saturday, 30 September 2023

Cut kitchen cupboard to allow for new fridge and hand some new floating shelves - Due date: Flexible

I’m looking for a cabinet maker to install some premade custom cabinets for a wardrobe and a laundry refer to attached documents and photos. - wardrobe- 4 cabinets, see photos and elevation. - Laundry - 1 floor cabinet 800x880x580, 1 overhead cabinet 700x800x300, 2 end panels, precut stone bench. Include install of a 2000 x 600 x 20 mm Cesar stone Benchtop at the laundry. All cabinets are supplied assembled. I might ask you to supply minor fixings at cost plus basis, depending on what’s required. All cabinets are in the garage. The laundry and en suite are one level up with good access. Two people who will be required to move the larger cabinets. Ideally, it would be done in the week of 11-15 September but can work around availability of the right person for the job. Make an offer. - Due date: Flexible

My fridge has an allocated slot in the kitchen, howeve cannot fit in because it is too high. If the kitchen cabinet and the doors on it are shortened by a few centimetres then the fridge will fit in perfectly. We have just moved and the current temporary location of the fridge is a challenge with toddlers. - Due date: Before Sunday, 10 September 2023

Install Stainless Steel bin hole into stainless steel bench Must have area fully sealed

There is a gap between the skirting board and the ikea cabinetry that my cat can squeeze between and I can’t get her back out. I would like the gap filled. It is at ankle height and under the cupboard lip. 7cm x 20cm approx. - Due date: Flexible

Custom Range Hood Cover required for kitchen renovation - Due date: Flexible

Need two shelves under kitchen sink replaced, as has timber rot on it due to leak. - Due date: Flexible

Cut shelves down around 100mm to fit behind pole - Due date: Before Friday, 18 August 2023