Find experienced local carpenters in Manly NSW

I have 2 pax wardrobes (100*236) that I would like to be assembled next to my fireplace. The measurements are a bit tricky so I need a carpenter also build me 2 frames on the bottom (like > https://www.youtube.com/shorts/D5gRUmK4tuA) so that they will fit. Also open for a solution to make it look better on the side as there will be +- 10cm of "open space" on the sides. So job will be build the frame, assemble the 2 pax units.

Budget is approximate. Send cost per hour of labour please. 1) Fix a wooden drawer 2) Hang 6 small picture frames 3) Install a hanging rack on a wall 4) Put up a baby crib

I have a timber benchtop from Bunnings and I need to cut the length from 2200mm to 1600mm. I will then need 2 more cuts made to the smaller piece.

Need somebody to polish welds and tube of a Balustrade it’s satin finish stainless steel. I’ll provide all the tools all they need to do is show up and do the work.

Fabricate as weld stainless steel balustrade on site

Need a stainless steel welder to help me on site

I need timber shelving installed in my garage which is part of a unit complex. I am thinking to support the shelving by affixing timber supports to each wall and then running further planks from side to the side for shelving . Pls see sketch design and basic measurements. I also need 2 bike racks fixed to wall and kayak pully attached to shelving. I have a video but could not upload. Let know your email and I can send this across. Garage length - 6500 Garage width - 2580 (estimate) Shelving length - 2950 (estimate) Work to be completed in next 4 weeks. Pls quote for supply and install.

Timber cupboard to be sawn apart and removed. There are no screws to disassemble.

Carpenter/Handyman for various jobs.

Details as above - refer to details in task. Needing hardwood timber decking stained and minimum two coats of staining. We put fake grass over the deck until the dog settled in. Deck is approx 5m x 4m. Thanks

Make and install cabinets as a tv unit around the fireplace - photos installed of the current space + inspo- please respond with a quote I can provide measurements

We’re looking for someone/company who is experienced in door restoration to help bring 8 timber doors back to life. Most of the doors have had some prep work started, some stripped, some partially sanded, so we’re now after someone who can help finish the job properly and prep them for a walnut stain to match our new floors. Details: • Door 1 (Front Door): Not yet started – both sides need full stripping and sanding. • Door 2 (Back Door): Not yet started – needs full stripping and sanding on both sides. We’d also like the swing reversed (left latch instead of right) if that’s something you can do. • Doors 3 & 4 (French Doors): Not yet started – both doors are the same on each side. • Door 5 (Bathroom Door): Not yet started – same on both sides. • Doors 6 & 7: Stripped but not yet sanded. • Door 8: Stripped and sanded with 60 grit on both sides – needs detail work in the cracks/corners. We’re aiming to match all doors with a rich walnut stain finish to coordinate with our new floors. Let us know your experience and availability – happy to share more photos if needed!

Place the shoe cabinet in the living room. There are stairs. As photo solid timber shoe cabinet 115 x 97 x 33.5 cm Today between 5pm-7pm

Remove three shelves in a wardrobe and replace with two hanging rods for clothes.

need someone to build a cabinet

Renovations. Deck, laundry bathroom Will pay hourly rate

Looking to sand, seal, stain and satin varnish my pine coffee table to a walnut colour that matches my dining table. The table can be disassembled to make sanding easier.

20 min job Need cables cut with Grinder or quality pliers or. Snips Then bugle screws taken out Total of 20 screws 10 cables Job needs. No ladder access is all easy thanks

Timber framing and decking on building site

We have a small cafe in Manly and we need a few small scale jobs completed instore after hours. 1. (convert a cupboard into 2 drawers)x 2 - custom drawers will be required as there are obstructions in the back of the cupboards 2. remove a panel wooden panel above a doorway and reinstall panel with an access door in the new panel.