Find experienced local carpenters in Hughesdale

Please read post carefully first. I require an Installer / cabinet maker to accompany my Cabinet maker tomorrow morning - leaving early AM to drive to Broken Hill NSW to install some joinery. Driving up tomorrow, installation Saturday, driving back Sunday. Please only apply if you have experience in Installation / Cabinet making with your own tools and have the capability / capacity to make this trip. Thank you.

Leg on my glass cabinet needs to be replaced or fixed

New staircase needs a American walnut stain on it

Need cabinet removal in kitchen and laundry, also installation of 80 inch TV is required

I’m looking for an experienced cabinet maker or skilled carpenter to help with a small but precise cabinet modifications and installation. Scope of works: • Cut existing laminate cabinet panels into: • 2 sets of cupboard doors • 1 upward-folding cabinet door • Install and align all doors using hinges provided • Mount 3 pre-cut existing cabinet panel inserts • Glue and install 1 pre-cut finishing lip to the underside of a cabinet • cut existing panels so existing cabinet door can be re hinged. so it opens fully without hitting adjacent laundry cabinetry (adjust or relocate hinges as required) Details: • All panels are already on-site and pre-measured (minor trimming required) and hardware, screws, wall plugs provided • No design work needed – this is a cut, fit and install job • Alignment, clearances and neat finish are important Requirements: • Ability to do clean, accurate cuts and precise hinge alignment • Own tools suitable for laminate cutting and cabinet installation

I need an experienced handyman/carpenter or metalworker to cut and shorten the metal legs of a cabinet. Details: • Current cabinet height: 95.5 cm • Cabinet body (without legs): 80 cm • Legs are metal • Goal: remove and significantly shorten legs so cabinet sits much lower and level • All legs must be cut evenly and precisely • New felt/glides to be added after cutting Cabinet is already assembled. Job needs clean, professional finish (not DIY uneven cuts). Required experience cutting metal furniture legs.

Need to fix the table top which was joined using 4 planks of pine sleeper. it is uneven and need someone to smoothen the surface.

Looking for an experienced handyman to help me do the below, so my cabinet and laundry bench top are flush against the wall. Scope includes: - Remove approx. 2 metres of skirting board from concrete wall - Wall mount the top of tall cabinet to a concrete wall. Bracket provided as per photo but please advise if not supportive enough for wall. - help me move side by side laundry with benchtop and cabinet back into position so it’s flush against the wall. You must bring tools suitable for drilling into concrete and appropriate wall plugs if needed for mounting. Timing is flexible but prefer sooner rather than later.

Deep scratch marks on my spotted gum timber floor.

New house has a carport that has been attempted to be converted to a garage. Require help to complete the job started by the previous owner. Requires innovative solution. Needs framing, cladding - so water tight. Water barrier at bottom of frame. Approx measurements: 6m long, 3m wide, 2m high. 3m already framed. Cement sheet cladding is fine. One 20cm fascia board needed at rear door Plastering not needed.

I need to make some space for the dishwasher. So need to take of the door and inside and make a small cabinet for the gap.

Removing old cabinets, making and installing new cabinets in the kitchen

Cat urine on mattress need help removing it

Cat urine stain on mattress

Hi there, I just need a chippy for a few small jobs around my newly renovated unit. The bottom part of windowsill in the kitchen is lopsided so need to replace this. I also have cornice missing in a small corner of the ceiling in kitchen. I have a lot of the skirting i pulled off still in the house so have kept this in case it's easier to re-use. Laundry door and front door need a small piece of wood put there- see image I'll need to bring supplies as I'm not sure what is required Images attached. Pretty small job - Due date: Needs to be done on Tuesday, 5 September 2023 - Due date: Flexible

I want to semi-remove/alter the size of a wooden cabinet above the fridge space so I can fit a taller / larger fridge * JUST PUTTING THIS TASK ON HOLD UNTIL NEXT WEEK> WILL UPDATE THEN> THANKS EVERYONE FOR YOUR RESPONSES SO FAR* - Due date: Flexible

Need to adjust kitchen cabinets to fit a dishwasher - Due date: Flexible

I need to get shelving done in wardrobes The wardrobe is 170 (w) 155 (l) Design is attached in photo - Due date: Flexible

Installation of a Bunnings supplied kitchen design, including cabinetry - Due date: Before Sunday, 30 April 2023

Require a cabinet maker specialist/supplier to assist with repair/realignment and replacement scratched/missing 2 pac kitchen cabinet doors/drawers for multiple units in Hughesdale, Victoria - Due date: Before Friday, 23 December 2022