Find experienced local carpenters in Hawthorn North

Hey there. I’m after someone who is able to build and install a cabinet/cupboard above my washing machine (washing machine not in photo). I’m after a cupboard that’s similar colour to the grey next to it, that just has two doors and adjustable shelves (nothing too fancy). It’s a relatively large space above that I would like to have as storage since my washing machine is a washer/dryer combo. Feel free to message for any questions :) Lucy

Shelf unit and cabinet unit I bought from Kmart

I need one small vent hole drilled into the curved stainless-steel dome lid. I will mark the location and confirm the hole diameter before work starts. Looking for someone experienced in drilling stainless steel who has the correct drill bit and equipment to securely hold the lid without denting or scratching it. Please remove any sharp burrs on both sides and clean away all metal shavings. No cosmetic polishing required. Located in Hawthorn. I can bring the lid to a nearby workshop. Please quote for this small job and let me know your earliest availability.

Looking for an experienced handyman or carpenter to carefully remove a temporary timber partition wall in an apartment. The wall is about 3.5 m high by 2.2 m wide and was built to divide the lounge and dining area. It is a timber-framed structure with insulation batts inside. It sits alongside an existing brick wall, which must not be damaged. What I need: Take the wall down carefully and methodically Protect the adjoining brick wall, floors and nearby surfaces This is an apartment, so noise restrictions apply. Work will need to be done during permitted hours and as quietly as reasonably possible. Please confirm: Your availability and a fixed price Please only quote if you have done similar internal demolition or partition removal before. Cheers,

Please help to set up my workshop space, by securing my benchtop and vice. Also set up my Dad's wood lathe, to re spark my turning hobby.

Custom Eyewear Display Cabinet Looking for an experienced cabinet maker/shopfitter to build and install a custom eyewear display in our optical store in Hawthorn. Approx 2400mm wide, consisting of: * Two equal display sections with a central mirror * Approx. 6–7 shelves each side * Integrated LED lighting * Timber finish to match existing cabinetry * Slim side panels * Existing lower bench/cabinetry and green fascia to remain

Need a front decking stained 1.5 x 14m estimate

Stained glass window to be fixed on-site. See attached images.

I have two of these hinged cabinet doors that I need taken off as soon as possible

Looking for a carpenter for Subby work, lock up & fix and internal framing. Hourly or day rate, ongoing work, must have all tools

My carpenter needs someone to help him today. Ideally a carpenter but will be open to a labourer

We are painting and I need a carpenter to help with bogging a small timber piece of the roof that has broken off as well as aligning some doors and fixing hooks / rails. Please bring own tools.

I am looking to replace my old front door with a new timber one, similar to the ideas below

Im moving out of a house and there's a brownish water stain on the roof. It's white and I need it painted over. I do not need the entire roof painted. Just a 1x1 metre colour match and stain blocker

Require rotten post circled in image removed and replaced.

Remove stain and paint a tiny little section of timber floor

Put cupboard in the practice, new Bench top in Reception area, Shelving around the practice.

Timber kitchen table water damaged needing sanding & re polishing

Seeking experienced cabinet maker to fix poor design of existing kitchen cabinets housing two built in refrigerators. Existing refrigerators need to be temporarily removed and an air vent/space installed (with fans?) to rear of cabinet to facilitate air flow and exhaust of hot air at rear of refrigerator into ceiling above. Also, door hinges need replacing as they are sagging and allowing doors to rub together. Price negotiable depending on solution.

Looking for someone to replace the wood veneer on the table and then stain. I have already sanded down the legs and sides. I'll cover the cost of materials (stain, wood veneer etc). The price is just labour. Advice welcome.