Hire trusted appliance installation services in NSW

Remove old washing machine door seal and replace with new one (I have purchased the new seal)

I need my rangehood removed and have a new solt 60cm Slideout rangehood that I have bought installed by a licensed electrician.

**Licensed Electrician Needed – Bull BBQ Rangehood Fault and Replacement Screen Installation** I need a licensed electrician to inspect and repair a Bull BBQ 900 mm outdoor rangehood. The rangehood developed an electrical fault while operating, which caused the electrical safety switch to trip. After resetting the safety switch, the digital display powers on and responds normally, but the extraction fan does not operate at any speed. The supplier has already provided a replacement digital screen/control assembly, which needs to be installed. However, the underlying cause of the fault is still unknown and may involve the fan motor, capacitor, internal wiring, control board, or another electrical component. The work required includes: * Safely inspect and diagnose the electrical fault * Install the supplier-provided replacement screen assembly * Test the digital controls and all fan-speed settings * Check the motor, capacitor, wiring, connections and control components * Identify any additional faulty parts or repairs required * Confirm that the rangehood is safe and operating correctly Please bring appropriate electrical testing equipment and provide details of any additional parts required before carrying out work beyond the initial inspection and screen installation. The rangehood is already installed, and photos and supplier information can be provided. Product details: https://bbta.com.au/products/bull-bbq-900mm-exhaust-fan-extractor-with-digital-display-304ss Please provide your licence details, relevant appliance or rangehood repair experience, availability and estimated cost.

My builder has installed a rangehood, but it doesn't appear to be venting outside. I don't see any vents either on the roof or the wall behind the kitchen. The cooking smells in the entire home especially upstairs. I would like to install a vent outside and get the rangehood connect to it.

Existing flange is removed and washing machine stripped so just need new flange installed

To install the merlin commander elite garage setup (preferably 10am)

Supply and install isolator and do hard wiring for induction cooktop. power requirement of the cooktop AMP draw 27.2A Power cord length 1m Supply voltage 220 - 240V https://www.haier.com.au/cooking/cooktops/60cm-300-series-electric-cooktop-hce604tb3-61825.html

I have Miele washing machine and dryer it’s not cleaning properly I think it needs service

Electrician will provide Electrical Power Provision. You need to help to install the rangehood. Duct can be put through the back wall fence to face the open sky (1.5feet gap between my fence and neighbour fence). Refer to the rangehood model and and photo of the marked install area. In photo on top BBQ fence the light will be removed and power provisioned and connectivity will be provided by the electrician. There is a single phase power subboard under the bbq cupboard from where the power is coming through behind the wall fence. Here is the product link which is already delivered at my place. https://devanti.com.au/products/devanti-range-hood-commercial-rangehood-bbq-hoods-kitchen-alfresco-canopy-1500mm?srsltid=AfmBOopLn3QYoWKoIHgyG8NhZUBDnqNoxe6dgVsYgTlbliWxZs7b87qx

Need a licensed electrician to install new induction cooktop and dispose of old one. We also have other work with some light installation we can discuss once it is complete

I have an Amantii TRD-30 electric fireplace that is completely dead with no display or lights. I need someone who can diagnose internal power supply, fuse, thermal cut-off or control board faults and then fix it if its an easy fix. The heater was purchased as brand new faulty from a shop. Located in St Clair.

Gasket spring on door got loose, tried reinstalling. Still leaks water. Needs a professional

Range Hood Installation Looking for an experienced installer to replace my existing kitchen range hood with a new one. Job details: * Remove the old range hood. * Install the new range hood in the same location. * Connect to the existing power and ducting (if compatible). * Test the unit to ensure everything is working properly. * Please bring your own tools.

Looking for an electrician to install a new oven, really straightforward job, just needs wiring (see photos)

New electric oven installed

I have an old integrated kitchen range-hood and I need someone to take it out and install a new one in. I have already bought it.

We need to replace the kitchen rangehood. We have bought a new one to be installed.

Scandia Aurora 74" electric fireplace. Install in lounge room internal wall. Wall appears to be drywall and timber frame construction, old weatherboard cottage. There is already power in the wall. Single phase.

I need someone to install the canopy rangehood for new kitchen

Remove old rangehood from kitchen and install new one. Already purchased. LG 60cm T-Shape Rangehood with ThinQ Auto.