5 Washing Machine Technicians in Docklands (Repairs and Installations)

Zanussi ZKG7125 washing machine won’t start, the display has no digits lighting up but I can only see there is a backlight on. Guessing circuit board need to be replaced

zanussi washing machine, pump needs to be replaced - will have pump on Monday

IT SWITCHES FROM WASHING TO RINSING WITHOUT DRAINING THEN STOPS FULL OF WATER

Hey there, my name is Chetan. I need to hire a handyperson to help me in Cubitt Town, Greater London. What do you need done? Repairs What is the type of property? Apartment Which areas of the property need work? Washing machine does not heat ; likely that heating element is needed- washing machine number is zki 245

Hello, The hinge of the door of my washing machine is broken and needs replacement. See pictures attached. Is there anyone able to help? Thank you! Stefano

I have purchased a new washing machine that needs to be fitted. May need to cut hole under kitchen unit for pipe work not sure as I’m not a plumber. Please bring tools with you. Many thanks

Zanussi washing machine drain pump needs to be replaced - I have purchased the replacement drain pump (authentic)

My washing machine (Indesit LV[Content Moderated] ) switches on and I select one of the main wash programmes. At the start, the drum fills a few cm with water but then the pump stops. The timer counts down but nothing happens. The drain setting drains the water out as usual over a few minutes. I've cleared the waste filter and checked the manual's troubleshooting which recommends cleaning the pump filter at the front right hand side behind the base panel, which I've done. The mechanism turns with the normal magnetic impedance. I have also checked the waste water pipe into the U bend - it's totally clear, as I expected as I have cleaned out the whole system a few months ago when sink blockages were occurring (all resolved now). I've switched it off at the mains for 10m and tried again several times after. The same thing happens. Another point to note - it initially flashed up "Error code F05" but this has since gone away. That apparently means "the pressure switch has “jammed” on. So the washing machine thinks it is full of water and refuses to spin" ([Content Moderated]