Find a professional heating and cooling technician in West London

Install a tado thermostat Note...I currently have a v2 nest thermostat I have the new thermostat Note - The Tado bridge and temperature sensor are already set up The tado 3 thermostat needs 4 wires connected which i assume match the 4 wires that connect to my existing nest 2 thermostat

We have a nest thermostat with hot water control setup already. Needs to be replaced with a tado x. Boiler sits outside and already wired to the heat link inside for the nest.

Boiler making sounds. Pressure high

Hi, one of the radiators in our bedrooms is not heating up, although all the other radiators in the house are working normally. We have already tried bleeding the radiator to release any trapped air, but it hasn’t helped. We are looking for an experienced plumber or heating engineer to inspect the radiator, identify the problem and fix it.

Maintenance & Repair for a 6 year old PAC15J (KYD44) from ClimaChill - needs a deep clean aswell

Keep getting an error message E.01

I need someone to reconnect my nest dial to my boiler

Bosch Serie 4 SMV46IX00G/41, a fully integrated 60 cm dishwasher is not heating. Cycle completes but dishes cold and wet. Needs repair or replacement assessment. Open to offers

I need my boiler to be serviced and certified

I need a certified gas business ro fix my Vaillant boiler. It shows F28 error and we don't have hot water.

Hive is set to off and not sending a signal to the boiler, however boiler central heating is still on, only way to turn it off is from boiler at the moment

I need to set up some tado x thermostats 8 zones I already have wireless tado x thermostat and receive to turn on and off hot water and underfloor heating, but zones not configured. Also underfloor heating has cold zones that I need fixed

Change the cylindrical thermostatic mixer for a dual shower unit

Lay loft insulation approx 12-15 strips

I wish to start using my heating and need to be able to increase or decrease temp from thermostat dial on the wall. It worked perfectly over winter but I think I have pressed the wrong button recently when I tried to switch it back on

There is a persistent water leak in one of the pipes beneath the boiler.

My latest epc check suggested I power clean my central heating system. I would like help to do so. I do not mind hiring the required machinery for contractor.

I have checked and is in working order, all the status lights are green which indicate the hive is connected and working and the same for the boiler as we have hot water. However the thermostat still does not send signal to heat up

Gas Safe Engineer needed for: Vaillant boiler, F.75 fault. Pressure is 1.7 bar, gas supply is working, reset has been attempted, and there's no hot water Free parking. Please say when you are available with your quote

Cylinder Heater Maintenance and Repair Currently no hot water at the flat. Heated Element Replacement needed. • We need to install 2x titanium-coated heated elements (we will purchase from Screwfix or any recommended supplier) in our indirect unvented cylinder heater in a 1-bed flat as they corroded. Cylinder Tank Cleaning • We also need to drain the whole cylinder and scrape/clean the bottom of the cylinder tank to prevent quick scaling of the elements. Please let me know your quote and if you can do the job before Saturday or Sunday this week. Any questions, just message.