Find an experienced handyman in Reservoir South

Installation of a bifolding door

I need my office walls to be sound proofed with some sort of sound absorbing wood panelling . I have attached the blank wall and what I’m after as well

Some tiles and grout in my kitchen and laundry are damaged. Looking for a quote to repair, and we can take it from there.

Install Ultimate supreme 17 fireplace into existing chimney space. I already have 3m of flue, but would possibly need a little more to complete the job. Floor already has been leveled and roll back knocked out for new unit to fit.

Qualified handyman to fix a door in the kitchen that is sticking and won’t close and replace rubbish bin system in the kitchen under the cupboard

Dry wall repair and paint. Need to match paint, Bunnings about a 5-10 minute drive away, approx 70cmx50cm Fix today if possible Need professional job only as it’s a rental

Supply and Install 2x internal doors including weather seals, automatic drop seal and a soft close latch Doors need to be solid core. First entrance - width is 0.824m, H 2.035m Second entrance - width is 0.770, H 2.043m

Repair four small wall cracks with putty and spray paint them after the putty dries.

Need someone to come and replace wall plaster. Want someone to remove the blackboard and fully plaster that section in the photo. Please provide quote accordingly.

Somone with attention to detail to come today to attach tv bracket dor 65# television and attach book shelves to walls. Pls note one wall is brick and other plaster.

Need fixing: 1 door to fix by screwing the nails(its fallen off),fix sliding cupboard - it needs to be attached. Did a DIY installment on new toilet seats - needs to be adjusted properly as the screws are loose. Toilet gets blocked every now and then - need someone to put through the silver snake as the first initial DIY fix. Should take more than 1 hour?

My shower screen is leaking water from the bottom.

Looking for an experienced carpenter/handyman/builder to design, source materials for, and install a custom sliding barn-style door inside my single garage to close off a large open wall section. I’m looking for someone who understands this type of build and can manage the project from start to finish, including sourcing all required materials, hardware, brackets, tracks, framing, fixings, etc. I do not currently have any materials purchased. Existing Space Total wall length: 6.4m Garage opening width: 3.47m Door to be installed on the inside of the garage Existing garage structure and wall shown in photos Design Goal I would like a modern barn-style sliding door that: fully closes across the opening when the garage isn’t in use slides open partway when access is needed For aesthetics, I would like the front of the door clad in: Ekodeck 219mm Hazlewood Batten Screen Castelled Panels from Bunnings (or similar if recommended) The finished look should feel warm, modern and architectural rather than industrial. Important Considerations Installer will need to assess: spacing around existing garage door tracks/brackets ensuring the panelling can sit flush and neat structural support for the weight of the door and cladding smooth sliding functionality weather resistance and durability best mounting/framing solution weather sealing or locking mechanisms are needed Budget & Timing Looking to have this completed ASAP Budget is approximately $1500 including materials, so please only reach out if this is achievable within budget.

Remove a motorised external roller shutter from a bedroom window. The window is 3 metres off the ground.

Bathroom sink is clogged and the kitchen sink aerator needs replacing as water is shooting out too strong and everywhere

Need some plaster repairs in corners. And one hole

I would like 3 min heated hand towel rings to be installed. 3 in total. Two will be fixed to plasterboard, one to a tiled wall.

I have straightened the walls just need someone to hang cement sheets on walls and plaster on ceiling of bathroom reno

Have purchased a new ceiling fan with a light. Will require new wiring.

Need to install the clothes rack bracket on the brick wall. This requires a powered drill with 10mm masonry drill bit.