Find a professional render repair in VIC

Have build the front fence recently and the rain didn’t help. The rendering has started to bubble up at few places on multiple pillar. See photos for more information

Some render has broken off the front of our garage, we would like it patched back in.

Just want a quote to render my back gargre

Brick wall, normally sits behind wardrobe, want to weatherproof wall to reduce moisture coming through from exterior, previous wardrobe had moisture, new wardrobe being installed 17 July. Want someone to clean wall then use products I supply to render over bricks. Just labor. 2h day one to clean and render. May require 1h on second day to apply second render coat. Need someone who knows and has experience with internal wall render.

Check and repair cracked house render

Looking for an experienced renderer to Render front wall of facade to match existing rendered wall colour as marked in the picture

My house front side ground floor needs Acrylic rendering on brick wall

Work required: • Cut out and repair cracked render (vertical cracking visible across approx. 1.5–2m section) • Re-embed fibreglass mesh where exposed/damaged • Apply base coat and texture coat to match existing finish (dark grey acrylic texture render) • Paint to match — colour match required What you need to know: • Existing wall is acrylic texture render, dark charcoal/grey • Must be able to match texture and colour — please don’t quote if you can’t do this • Photos attached

Need a renderer to fill cracks in front facade

Some damage on a column out front of my house. Looks like patching of render to be done. Size is small enough about 20 cm wide ( small area looks like Ute has backed into.)

Need render touched up and painted. Small cracks at base of render and gaps need to be filled

Need this wall rendered front, top and maybe 100-200mm on the inside. 7.7m long x 3 courses high.

Looking for someone to patch up this render holes and failed patching job

Minor rendering patch on a garage wall- see photo attached.

Exterior corner of house has developed a crack and separation near the eaves/fascia. Looking for someone to repair the damaged section. May involve render, timber trim, or fascia repair if possible please inspect and provide a quote. Thanks More details: A trim board/cover on the exterior corner of my house is missing(circled in red), leaving the edge of the eave/soffit exposed. The matching trim is still present on the adjacent side( circled in green). need the missing section supplied, installe. Please inspect the area and advise if any additional repairs are required. Also in the photo with a single red circle, I would like the crack to be patched. In the last photo the section marked in blue appears to allow water ingress during heavy rain. I’ve noticed water seeping through this area, which may have caused the discolouration in the area marked in red. The second last photo shows the same area (yellow section from the first photo), but taken from the first floor. In this section, there appears to be a gap in the blue area where water may be entering. Could you please also check this area and advise if it needs sealing (e.g. sealant or waterproofing), along with the other repairs? Thanks This is a 2 storey townhouse

Base coat pillars and beams - supply render - base coat only Angle beads installed already

Just demolished an outhouse and need rendering for a feature wall. The size is 2000mm wide x 3000mm high. The corner on the right will need a deeper fill and will most likely return around 100mm on the right hand side wall. Render just the minimum thickness required and a cement colour finish is adequate. Not too sure of tge cost, hence I've put a minimum of $10.00

Exterior Render Crack Repair – Reappearing Crack Looking for an experienced renderer / exterior repair specialist to repair a recurring crack in exterior house render. Crack is approx. 90cm long Previously repaired but has reappeared Area has not been painted yet Need repair assessed and properly fixed to prevent further cracking Exterior access is straightforward Please bring your own tools, materials and equipment. Would prefer someone with experience in render repair and crack prevention rather than just patching cosmetically. Please include: Your experience with render/crack repairs What method/materials you’d likely use Availability Quote or estimate

Render work needed infront of the garage

I have a set of fleximount shelving that needs to be installed inside the garage. The garage walls are brick. The mounts need to be drilled into brick and not the mortar. Ive given up trying to get the holes to line up straight. There are approx 48 holes to drill.