Find an experienced handyman in West Adelaide

Dismantling a cable machine and treadmill from the garage and moving them both to the granny flat out the back and reassembling them both.

I have a swing chair I’d like to install inside (upstairs bedroom). I might need a beam in the ceiling but unsure.

I'm seeking a general handy person for a range of tasks. Will need own tools including a spirit level. Experience building Ikea furniture is preferred. Build an Ikea Billy bookcase then secure to wall. https://www.ikea.com/au/en/p/billy-oxberg-bookcase-with-panel-glass-doors-white-s79591858/ Attach legs to an Ikea Besta unit then fix doors. https://www.ikea.com/au/en/p/oesarp-leg-brass-colour-70489902/ The legs will attach to a pre-built Besta unit. Attaching the legs will join separate units together. The doors on the Besta unit have not been well installed and some need to be straightened. The Besta unit is similar to this: https://www.ikea.com/au/en/p/besta-storage-combination-with-drawers-black-brown-lappviken-stubbarp-brown-walnut-effect-s49630540/ Hang curtain rods: https://www.ikea.com/au/en/p/vidga-two-track-wall-set-white-s49428265/ The tracks require an extension. A third track piece needs to be cut in half to extend the two tracks. You will need to calculate where to install to wall brackets to manage the join. Hang 6 pictures in a straight line: https://www.ikea.com/au/en/p/edsbruk-frame-white-20427327/#content Available 31 July, 1 August, 2 August

2 bathroom mirrors installed to 2 separate bathrooms with tiled walls. new build. Metal frame house.

Currently have a single fixed frameless glass panel forming an open walk-in shower with no door, causing water to escape onto the bathroom floor during use. Looking to have this removed and replaced with a new 900mm x 900mm framed shower screen including a hinged door, to properly enclose the shower and stop water escaping. You can suggest an installation of a door at one end if feasible for the current setup too. Scope of works required: remove and dispose of the existing fixed frameless glass panel, including removing all silicone sealant from the wall and floor junctions. Clean and prepare the wall and floor surfaces, removing old silicone residue and filling any redundant fixing holes. Supply and install a new 900mm x 900mm framed shower screen with a hinged door Ensure screen and door are level, square and operate smoothly, with correct door swing clearance. Silicone seals all edges (wall, floor, and panel joins) to provide a watertight, mould-resistant finish, sealing only on the outside face per standard practice to avoid trapped moisture. Please let me know if you have any further questions...

Someone experienced with net installations to Install some new netting , which we have purchased , at a indoor sports centre - the placement of the net is about 8 metres off the ground so a scissor lift is needed.

Looking to install aluminum wood look batons between two posts on our outdoor entertaining area to look similar to this AI photo - looking for quote as not sure how much the cost would be

Select and erect curtains that cover this glass door and also cover upper window. Select material suitable for room (colour), install with curtain rod.

Need drill holes fixed, patched and painted over to repair damage

The shower screen has come off its track and is no longer operating correctly. The door appears to have become dislodged from the runner mechanism, preventing the door to slide properly.

Door frame and sliding door scratches by dog. It is a rear sliding door. Looks like Matt black paint on aluminium door. Scratches on glass door frame and sliding door frame. Also require replacement of the fly screen. It’s the kind you get from Bunnings with the roller. Need to supply paint/spraypaint/fly screen.

Damage to ceiling gyprock due to an accident several months ago. Scope of work needed: Remove the protective sheeting. Prepare and Clean the ceiling framing. Supply and Install new 10 mm thick ceiling grade plasterboard in approx. 12 m2. Cut holes x 3 for ceiling downlights into new gyprock sheet. Back block edge joints. Fill, Tape and Flush the abutting edges. Sand over the applied fillers ready for painting.

Bathroom ceiling cornice install 2.7m high ceiling

Repair some nail holes make surface good and paint over (supplied) Paint one wall, repair minor damage to two internal doors, make good and paint.

Fix the hole in one of the wall in my house

I need someone to install my Milkcan clothesline into concrete. For this install the height and length need to be shortened, as well as installing into concrete. Please see the attached instructions to confirm if you are able to complete this: https://cdn.shopify.com/s/files/1/0908/1775/7496/files/13-line-above-ground-clothesline-instructions.pdf I do not have the tools required for this, so you will need to supply these. My preference is today 18/6 while there is no rain, but can be flexible.

Plumbing required to lower vanity tap and washing machine taps lower so that a new vanity and laundry bench can be installed , will need someone who can cut out gyprock to get to the pipes and then patch up . Need to supply and install washing machine valve and connect to washing machine.After a new laundry sink is installed will need to connect sink and new mixer tap.

*Access roof cavity via man hole *Terminate 3x sets of ceiling fan wiring *Pull up any associated switch wiring also

I'm looking for a single person or duo that can move/swap three queen mattresses and put one standing up against a wall. I'm also needing a tv cabinet swapped and one measured (as it has to be given away). I'm looking at no more than $50 an hour.

Seeking a professional plasterer who can undertake the following: 1. Supply,paint and install skirting piece to match current (as seen in photo). 2. Plaster the wall to patch holes from cavity left by wall mounted heater. 3. Paint both skirting and wall to match. Includes supplying small quantity of paint. 4. Optional if skilled. Patch the carpet in front, happy to take from a wardrobe. 5. Touch up other downlighting with the same paint where LEDs have been installed (as pictured). 5 total. I included what I believe to be the paint used by previous owners. I believe paint has spoiled but may be helpful with colour matching. Let me know if you have any further questions. Thanks! Note: post has been updated for more clarity.