Find a professional cement sheeting contractor in NSW

Replace and dispose of 1 asbestos sheet on garage wall, Meas 2060 x 900.

At Unit 14 / 50 Riverside Drive Mayfield West NSW 2304 The fibre cement sheet of the external facade of the warehouse has a roughly 15 to 20cm chip which will require it to be patched up and painted.

fix baton to underside outer edge of under balcony to create gradient for water runoff. fix cement sheeting or other material if better, to underside of balcony and finish edging. Measures 23m2. - Due date: Needs to be done on Wednesday, 15 November 2023

Help install cement sheets on framed ceiling. Area is 7200 x 2200. Materials are onsite. - Due date: Needs to be done on Tuesday, 15 November 2022

Finishing off pool cabana… - Back triangle needs to be filled with weatherboards on outside and fibre cement panelling on the inside. - All eaves to be cut and attached. All materials supplied. Approx size of building is 5 x 3m - Due date: Flexible - Due date: Flexible

Take two sheets of cement sheeting from Bunnings. - Due date: ASAP. Needs to be done on Sunday, 30 October 2022

Fibre cement sheeting required to be installed on an alfresco ceiling and two walls. - Due date: Flexible

fix broken cement sheeting - Due date: Needs to be done on Monday, 19 September 2022

About 24square meters of deck joist undersides, posts and deck skirting plus deck overlay with 30/30/30 sheeting - Due date: Before Tuesday, 14 June 2022 Needing quotes please

Remove existing Trimdek? external wall cladding (approx 11m) and replace with fibre cement cladding sheets (approx 8mm thick x 0.9m wide x 3.1m high). Add a run of fibre cement cladding along the top approx 150 deep as a fascia after the new sheets are installed. ... and maybe install a run of guttering. - Due date: Flexible

I have removed the tiles on upstairs bathroom and need fibro cement sheets to install before waterproof 4 square metres area?I have the sheets - Due date: Needs to be done on Saturday, 21 May 2022

I need a wall built to replace my existing timber boundary fence. The fence should be built using cement sheeting and ideally with metal posts to last much longer than timber. A product like hardie fine texture with minimal vertical jointing would be preferred. The fence should be built with a level top edge stepping down where necessary to accommodate the very gradual slope and ensure a fence height of between 1.8 and 2.1 m. The fence is just under 9m long. The fence will continue on from a rendered block fence (see photos) and needs to look similar. It continues past a glass pool fence and finishes about 3m into our pool area where it joins to another block wall (the neighbours garage). The wall needs to pass no more than 50mm away from the glass pool fence. The wall should be clad on both sides. There is a rainwater tap attached to a post that will need to be attached to the fence instead. Ground level is the roughly the same on neighbour and my side of the fence, no more than 100mm difference. There is a hole on my side of the fence where I removed a tree stump. It's approximately 600mm deep by 600mm diameter. Note: Hardie Fine texture sheet are already prepped for painting. If you are quoting based on a different sheet type, please include details of the sheet type and whether the joints are the similar or different to the Hardie Fine texture product. Also include prep for painting in your quote if the sheet is not already prepped. Please include removal of existing timber fence in your offer. Please submit details of your quote with your offer. I am happy to provide more details of the job if required to quote, just ask. Job can be done any time between now and due date.

Repair/ Replace fibro cement sheets Gyprock work Extension of deck installaton & convert into rooms including laying roof - Due date: Flexible

All materials on site: * Sheet / plasterboard 3x walls * replace old fibre cement floor with new one I am on-site and will provide general labor assistance

I need to remove a bathtub, toilet- which have already had plumbing disconnected (so just pull them out), and remove tiled fibre cement flooring from joists. The aim is to lay a timber floor on the joists. The area is approx 3.5mx3m - Due date: Needs to be done on Sunday, 14th Nov 2021

Need a builder to supply and install FC Sheeting to the building awning. See image. The missing sheet needs a replacement and the broken sheet needs fixing. There are a couple more. Its an apartment building. Address is 102-110 Parramatta Rd homebush

Have cement sheet just need 2 strong people with some know how to put it up in our shed roof probably 2 hours work for 2 people

Need to get someone to cup grind my deck preferably someone with a large machine to grind the cement sheeting to remove waterproofing membrane ready for new membrane. Area is around 50m2

Would like to lay concrete cement sheets on old suspended timber/vinyl flooring in order to create a smooth surface for laying new tile/timber floor in wet areas. Approx 6m x 11m

There are two ikea shelves with 3 holes each It is to be mounted onto a guprock wall that has a cement sheet backing it. I started to the job thinking it was hollow behind the gyprock which I can do however I have drilled through to a cement sheet. The outside wall is not brick so it’s a sheet of something and I don’t have much experience drilling into cement sheets and fixing things to it hence my task request Need someone to mount the 2 shelves and also supply the appropriate fixing to mount the shelf also . Located on Ashbury - shouldn’t take longer than 15 minutes .