Find experienced local fencing contractors in Bentleigh East

PLEAEE SEE ATTACHED PHOTOS Cut and remove 2 sections of brick fence to allow vehicle crossover to connect to driveways. There are two sections of the fence to be cut and remove as follows: 1. Section 1 is half removed. You will remove the rest of the marked section then construct a brick pier on either side of the removed section of the fence. 2. Section 2 of the brick fence is very low. Remove the marked section of this fence. Then construct a brick pier on either side of the removed fence. You will bring and use your own equipment. The site must be cleaned up after you are done. Please quote only for the entire job and no hourly rate offer.

I have some lattice attached to my side fence. Some of the horizontal panels have warped and need to be nailed back to the vertical panels. A nail gun will likely be the easiest way to do that

I need to replace the existing fence with the new timber paling fence. Standard height 1.8 m. Approximate length of the property boundary is 42.6 m.

We have a townhouse property and would like to get a quote for fencing installation. The project includes: * Front yard fencing * Driveway gate (manual operation only, no motorized or automatic gate required, lock and keys required) * Raising the height of the existing shared boundary wall with the neighbour by installing fencing on top * Pedestrian gate (no ring bell needed, but lock and keys required) *Please don't forget that the small section above the mailbox also needs to be raised to 1.5 m.In short, all visible parts should be built to a height of 1.5 meters. Requirements: * Total fence height not exceeding 1.5 metres * Black aluminium picket style similar to the attached reference photos * Durable and low-maintenance materials suitable for outdoor use Please provide an estimated cost, installation timeframe, and whether a site inspection is required.Because this involves a shared boundary wall, we need to obtain our neighbor’s written approval. If possible, could you please let us know what work will be done to raise the shared wall and what the finished result will look like? A rendering or visual mock-up would be greatly appreciated. The property is located in Bentleigh East, VIC. Thank you.

Our bamboo style fence has blown down in the wind, just needs to be put back up and fastened tightly so it doesn’t fall down again.

Replace fence (roughly 2m) with gate.

Need to build a boudary fence for a house in 3165 post code in victoria. Need a quote after visit site

Timber paling fence to be erected on 3 boundaries. Old one to be removed.

I want to install some type of fence that needs to be atleast 100cms tall with no horizontal bars for my kid to climb on, on an opening that is 250cm wide. I checked all the readymade fences and they are too short in height and not sturdy enough

Install the side gate. Only gate available and nothing else.

Install a Babelio baby gate with hardware at top of stairs

Replace timber fence post and also replace broken paling with new ones. Yellow metal post can stay

I need installation of a front gate at my house. I will source material Myself whatever you need for this installation and I will pay you labour for This task. It will Be sliding aluminium blade gate 1.5 high .with motor.

need a quote to install a **40 metre timber paling fence** for left boundary of the lot: - Height: 1.8m - Straight line - No decorative features - Ground: level - No complex site obstacles -removal of the existing fence -requiring you are fully insured

We currently need hire 1-2 tradies who have experience on timber / colorbond fence installation. Can do full time / part time.

Require an experience fencer to remove a section of property side fence and patch a gap in the same fence.

need to replace old fence as shown in photos below

X2 fence posts are leaning - need repair or replacement. One of them is inaccessible because of shed. Therefore need new one installed just before that one to take load.

I need a guy to give me a hand to install a front fence in Bentleigh East Tuesday morning. There is a sliding gate, pedestrian gate and one fence panel. Should take 6-8 hours and can pay cash $35/h. Just need a hand to help me put them in place. There is no need for a tool experience! Must be Tuesday morning around 8.30 am

We have no front fence and want a brick fence to match same used on the house. Its roughly 15m length would like a brink fence built. Will need to level grass. Flexible with date