151 Electricians in Sydney Northern Beaches

Hi, I have a down light that I need replacing with a new fitting and a brand new ceiling fan that doesnt go around. Im in North Manly. thanks

We had some storm damage and we have lost the lights on the ground floor - still have socket power (see photo of fuse board - one fuse has tripped). Need to get this back up and running. There is access via a whole in the ceiling to the front rm - see photo. There will be other work to do as well which you could quote on while here. Please quote for this work.

We had some storm damage and we have lost the lights on the ground floor - still have socket power (see photo of fuse board - one fuse has tripped). Need to get this back up and running. Also want to install downlights upstairs, and change power points and switches - approx 13 lights, 10-12 double powerpoints and 8 switches. Also new fans in 2 bathrooms. Also need a light added to the stairway, point added to the outside terrace, and lights replacing in the 2 outside areas (please see photos). There will be other work to do as well. Please quote for this work. Ideally all downlights/power points supplied by you (hopefully trade prices), but open to discussion on this. Fans and outside lights we can supply.

I have two ceiling fans I would like installed.

Wire in replacement bathroom fan with heat lamps, wiring and unit in Position Swap over of Hunter Pasific light fan combo as broken, spiggot that attaches light to fan motor has broken motor is working

I need a licenced electrician to replace 7 oyster ceiling lights and a single spotlight with these lights (already purchased): https://www.beaconlighting.com.au/ledlux-textie-320mm-led-grey-flush-mount-in-warm-white https://www.beaconlighting.com.au/nevada-1-light-spotlight-in-white In a ground-floor Manly Vale unit. Any time in the next week, we are available most days.

Put in 2 power points in garage and 1 ceiling light

Damaged Telstra copper from branch. Simple isolation, cut, rewiring. Phone line is out back of apartment block on ground-easy access

Looking to have 3 pendant lights replaced with surface mounted down lights, by registered electrician. In addition, one power socket (in kitchen island) is not earthed - looking to have this fixed. Flexible timing wise.

Service and brake pads replaced

Installation of 4 Smart Security Light With Movement Activated Sensor. 2 at front of house and 2 at back. I will buy the lights.. Would you to replace current old sensor lights with our new purchased ones.

Great lamp has unfortunately come unwired. Needs to be rewired Flexible as to when this gets done

Supply and install a power point, and tv aerial point Replace porch light fitting (new fitting supplied) House is single storey and timber stud internal walls

My parents have had an 8kw and two x 3.5kw Samsung split system aircon units installed at their house but we've found out the switchboard didn't have enough connection points so I need an electrician to come install a new circuit, safety switch and isolater and run power to the outdoor compressors. Good roof access available. Two compressors located above carport roof (can walk on). Third is about 2m off ground towards rear of house. Single phase. Location Balgowlah. My satellite picture is to give a rough idea of location of Switchboard (S) and the 3 outdoor compressors. Must be licensed and fully insured with evidence provided. Air conditioning professionally installed bit their license limited them to only connecting to an existing circuit not running a new one. Any further questions let me know.

Bridge tap fault NBN won’t work

Hi we have a cafe in Manly. Backside light box came off and it’s needs to be fixed.

I have a 15m boat that I need help to wire up I have radios,fish finder, control panel and nav lights

Our Electrolux Front Loader is showing an E20 message and the machine is struggling to completely drain. In the past I have cleared the drain and it has been aok however am unable to do this myself this time. It would also be good to have the seal around the door replaced. The model is an EFW12832. ideally the job will be completed in before noon of 30 March 2021 (tomorrow). Message me for further information.

Existing set up is HFC and we now need FTTC connection. That means telephone line from Telstra/NBN box on outside wall to our current Telstra connection box and smart modem. Easy access via ceiling space. Distance from outside box to modem and connection box is around 15m. Will need the telephone jacks for connection box only as we do not want/use a landline phone.

I have quite few shelves (5) and a mirror that needs hanging. We’d also like you to install 2 hooks for hanging plants. Thanks!