Find trusted local electricians in Plumpton VIC

Looking for a fully licensed electrician to install 4 light fixtures in a standard single-storey home. All fixtures are 100% unpacked, prepped, and ready for a straightforward installation. ​Job Details & Layout: ​1x Meshmatics Wire Mesh Chandelier: Lightweight wire mesh fixture, needs suspension cable adjusted to height and wired. ​1x 98-Strand Crystal Chandelier (Dining Room): Pre-assembled, shortened/modified to height, and bagged for quick mounting. Needs attachment to ceiling joist/timber support. ​2x 3-Light Pendants (Telbix Ahern - Kitchen Island): Split-link chains need to be sized and rest is ready to mount and wire. Needs attachment to ceiling joist/timber support. ​2 lights installed. Lights provided, only wiring required. ​Please confirm you are a licensed electrician

Need a licensed electrician to change light fittings for 6 lights. Cabling and connections already exist. Only need light fittings to be changed and fixed to wall and ceiling. Total 6lights: X4 outdoors fixed to bricks X1 fixed to plaster ceiling X1 fixed to plaster wall

Supply and change one down light & supply a $20 string from Bunnings and put it on a clothes line

Disconnect the old heat pump hot water service as it’s hardwired to the house and install an outdoor weather PowerPoint?

Looking for a licensed electrician to install a BYD 7kW home EV charger in my garage. Single story house

Change 3 flickering downlights

Looking for a certified electrician to supply and install x5 90mm downlights in place of existing down lights

Installing two 3-pin power points in a kitchen (Under the kitchen benchtop). The extension connection from the microwave.

TITLE: Licensed electrician — hardwire sauna heater (dedicated 25A circuit) DESCRIPTION: Need a licensed A-Grade electrician to run and connect a dedicated circuit for a Harvia sauna heater. The job: - Run a new dedicated circuit from the switchboard to the sauna - 4.5kW single-phase heater — requires 25A MCB, 3 x 2.5mm² supply cable, RCD protection - Cable must be rated for sauna conditions where it enters the room (silicone-insulated) - Install isolating switch outside the sauna, within sight of the heater - Terminate at the heater's terminal block (located at base of unit) - Test and issue Certificate of Electrical Safety What I'm supplying: - The heater havia sw45 and manufacturer's installation manual with terminal diagram - Heater will already be mounted on its wall bracket Site details: -Fraser rise], Double sided going in balcony upstairs - Switchboard is approx 10 metres from the sauna,upstairs balcony behind the house. Switchboard is in gartage Please include in your offer: - Whether the quote includes the cable run and all materials - Any switchboard upgrade you think is needed - Your licence number - Earliest availability Happy to send photos of the switchboard and sauna location.

I am looking for an experienced and fully licensed Electrician to do a few electical works as per below: 1. Installation of the following: 5x new downlights 1x new 3-light pendant 3x replacement of outdoor lights 1x heated towel rail installation (3-light pendant, outdoor lights, and heated towel rail provided by me) 2. Installation of 4x new double powerpoints 3. Wall mount 2x 75" TVs (will need extra care as one wall is behind the ensuite and will have some water pipes) The house is single story (less than a year old) with internal roof access via manhole. Certificate of Electrical Compliance/safety (COES) to be provided by Electrician upon completion.

I need an electrician to install two indoor light sconce in my tv area. One on each side of the tv - as per the picture.

Require a power point installed on the tiles where the toaster is in the picture, Needs to match the existing PowerPoint on the other side of the bench top which appears to be a Clipsal Iconic Double type. It’s a townhouse so the wall backs on to the neighbours place, there’s also no roof void so only place an offer if your confident you can do job with this in mind, and can also do without damaging the surrounding tiles. You’ll need to be licensed to install and provide a Certificate of electrical safety along with supplying the matching double power point. Any questions please reach out.

Connect hardwire kit to fuse box

Leak on hot water solar panel to be fixed

I am looking for someone can supply and install smart/wifi switch for electric water heater.

Hi, I need help with someone supplying and installing 2x Clipsal Iconic double power points. You’ll be supplying all parts/materials required. Please quote accordingly.

Need a licensed electrician to install 1 pendant light in the dining room of a double-storey house(ground floor/no existing wire.Please provide quote and availability.

Seeking professionally licensed electrician to install 4 standard power points in our single storey house (built 2018), in Fraser Rise. Interior walls with standard timber and plasterboard walls; standard / high pitch roof with access to wall studs. Certifications required: A-Grade Electricians License and registered as a Registered Electrical Contractor (REC).

We have a replacement pendent light, need someone to come take this down and install new one

Another electrician has already done the cabling for 3 PowerPoints, we just need it finished up and Rangehood installed. Please only make an offer if you’re available tomorrow