Find local power point installers in Plumpton VIC

Installing two 3-pin power points in a kitchen (Under the kitchen benchtop). The extension connection from the microwave.

Require a power point installed on the tiles where the toaster is in the picture, Needs to match the existing PowerPoint on the other side of the bench top which appears to be a Clipsal Iconic Double type. It’s a townhouse so the wall backs on to the neighbours place, there’s also no roof void so only place an offer if your confident you can do job with this in mind, and can also do without damaging the surrounding tiles. You’ll need to be licensed to install and provide a Certificate of electrical safety along with supplying the matching double power point. Any questions please reach out.

Hi, I need help with someone supplying and installing 2x Clipsal Iconic double power points. You’ll be supplying all parts/materials required. Please quote accordingly.

Seeking professionally licensed electrician to install 4 standard power points in our single storey house (built 2018), in Fraser Rise. Interior walls with standard timber and plasterboard walls; standard / high pitch roof with access to wall studs. Certifications required: A-Grade Electricians License and registered as a Registered Electrical Contractor (REC).

the front door, main bedroom and second living

3 power point to install

need a power point and connection for electric cooktop in the kitchen of a new house from the main line .

Looking for a qualified electrician to install a power point next to bathroom sink

need double points installed . 2 double power point switches downstairs. one double power point in the bathroom upstairs.

Wanting to add power point to marked area, looking to add switch to current switch board pictured. No power source behind wall which is closer so best source would be led light above. Thank you

We are seeking quotes to cover the following services: 1. Install x2 new power points in our theatre room. (Closest existing point is behind this wall, at a right angle, on the exterior wall) 2. Install x1 new power point in our laundry room. (There is already one there at a higher point on the wall, the new one would go directly below at the standard position) 3. Replace existing ceiling lights from standard bulb fitting to downlight fittings: x1 toilet room, x1 bathroom, x1 wardrobe Note: The wardrobe light is desired to have a motion sensor capability (if possible, based on advice and estimate). I already have downlights so should not require quotes to include these parts (with the exception of advice on motion based request in the wardrobe). Single Storey House with colorbond roof.

I require a licensed electrician to install two lights and two power points.

Need two power points supplied and installed as shown in pictures

Needing 6 power points installed around the house.

There's a light switch that I need a power point next to it

Installation of outdoor power point required - Due date: Flexible

New power point in laundry and check out my bedroom ceiling fan as it’s stopped working