Find trusted local electricians in Kensington VIC

Safety switch turned on, lights in the house work fine all plugs stopped working , trying to identify which plug is faulty and fix it.

Smoke alarm is chirping and needs to be removed from ceiling. Ceiling is too high for me to get to it and afraid of heights.

1. Fix hallway lights (tried new globe still no good) 3. Move PowerPoint besides stove to bottom of wall 4. Move ceiling fan from kitchen area to spare room

The outside power outlet that serves our pool equipment is not providing power to any of the individual outlets.

I’m looking for a licensed electrician to help with a few small electrical jobs: Picture 1 • The left switch is faulty and needs replacing. • The right power point/switch does not allow power adapters to sit properly and may need adjustment or replacement. Picture 2 • The light switch is faulty and cannot be switched on. • One of the heater switches is faulty and must be held down to turn on the heat light. Please supply and replace parts as required, and ensure everything is safe and working properly. Happy to provide photos and arrange a suitable time.

I have a 1950s-60s era vintage floor lamp that has had the power plug cut off it. I require a registered electrician to rewire the lamp, attach a new power plug and test that it’s operational and safe. Please note that I don’t have a replacement power plug but can buy one under your direction or you can provide it and this can be added to your Airtasker fee. Please only respond to this task if you’re a registered electrician, thanks!

Multi room LG Model LMN2166E2L (3517) requires repair. Possibly capacitor issue. The outdoor unit just makes a clicking noise when indoor units (2 in total) are turned on.

Just need a smoke alarm battery and 2 light globes changed. Will supply parts and ladder.

We are looking for a certified electrician to do the following jobs. -Moving one power point down under the benchtop, preparing for washing machine and dryer, checking with the capacity of the cable for running through two machines,capping off the powerpoint. -Capping off five power points in kitchen. -Disconnect and removing the slideout rangerhood, Capping off the powerpoint. -Installing 10 Led downlights. There are 8 led downlights in kitchen/dinner room and 2 led downlights in laundry/toilet room. There are two ceiling lights need to be isolated in kitchen. -one powerboard upgrades to 3 gang board. -installing one sensor light in front door. Downlights, lights and powerboard are supplied by owner. Cables and plugs are supplied by tasker. Valid Electrical work certificate EWC must be provided upon completion.

Need an electrician to rewire the fan so that it always has a power supply and can I control it with remote. There is a light and fan in the loft. If the switch is off then can't run the fan. If the switch is on can turn off the fan light but not the other light.

5 halogen down lights in ceiling of 15 lights are not working even when bulbs are replaced - transformer needs checking and perhaps replacing. One electrical point in a child's room is unsafe and needs to be removed.

I need 11 Downlights along with Plug base to be installed in my apartment. I have the downlights and plug base with me.

Hello, I’m looking to have an existing ceiling light removed and replaced with a new pendant light (photos available if needed). The wiring is already in place from the current light fitting. Could you please provide an estimate for: Removing the old flush-mount ceiling light Installing the new pendant light in the same spot Location: Kensington 3013 Preferred timing: [insert your availability here] Please let me know your call-out fee, approximate total cost, etc. Thank you, Lisa C

Hi, Electrician needed to pull 2 new lines in my factory in Kensington Vic 3031, needed 2 new power point of 20amp which i think needed new line.

i already have the downlights, just need help with replacing and swapping out downlights

In after an electrician to: 1. Replace 2X light switches 2. Replace 2x fans in bathroom 3. Reconnect one fan to the switch (it is all wired however was disconnected for safety as fan not installed properly) 4 join a fan and light switch (2 seperate buttons right now on the one switch) so you just turn light on and both light and fan turn on I can get the new light switches (2 of them) and fans (2 of them) or happy for you to bring . Image of the light switches attached I can also get bathroom fans or if you have, happy to pay cost price

In order to install multi-split systems, my older switchboard needs to be upgraded. A switchboard upgrade is required for a double-story terrace house to be compliant with current Australian standards. The compliance certificate will be provided after completion.

I need a light fitting changed pendant light in kitchen

I have an Error Code 7 (disconnection between inside and outside unit) on my AC. Was working a few months ago and then has sat for a long time. Have been advised it might just need a good cleaning and the connecting wires checked.

We would like an electrician to install an nbn wall socket to which we can connect our wifi modem