Hire an Electrician for any job in Fitzroy

Looking for someone who is skilled at desk cable management and overall clean setups. We require the following tasks to be completed; - Power boards to be screwed into the bottom of the desk - Hole to be drilled into table, feeding cables up from server to screens, computers on the table. - Wires to be well arranged and out of sight (as best as possible) - Data solutions, running cables to our upstairs office. - Direct network cable from our server up to the screening room We have all the cables and IT equipment required.

Exterior sensor light is remaining stuck on

Need an electrician in Fitzroy to hang pendant lights x 2, re wire and repair old wiring

I severed my NBN lead in cable this morning. NBN can’t come till WEd. Is there anyone else who can repair this for me? It is the black cable leading from the “Telstra” Box on the side of the house, up the outside wall and into the house. I was trimming a hedge against the wall and cut the black cable.

I’m looking for someone to safely disconnect a light box and remove it from the front of my shop.

Replace a pendant light with an IKEA Bave track light on the ceiling. Drill required to screw the track light strip onto the ceiling.

Looking for an electrician to replace one pendant light with another. Please see attached picture for current light set up, the ceilings are high and require a tall ladder. Thanks!

My LED projector lamp has broken, I have taken it apart to locate the issue - it seems it just needs to be soldered? I would be happy to drop off and pick up within 40mins of Fitzroy, Melbourne tags: electrician, electric, lamp, lighting

I work in a shared studio space that has a few light globes that need changing. I have the globe for one light but the others I need to see what kind of globes they are before purchasing. The ceiling is over 3-4 m high and I don’t have an appropriate ladder. I need help getting up there and changing some globes. Thank you!

2 light fitting not working. One is broken and light handing by cabling and other is not turning on (potentially issue with light switch) Note, light fittings located on the ceiling of warehouse apartment ~4.5m high If required, do have a ladder that can be used. Not electrically isolated. Thanks, Alex

Hi, Looking to get someone to help with 1) replacing/fixing a bathroom fan as it doesn't suck very well, and 2) adding a timer/delay so that fan turns off after ~5minutes. Cheers.

Requiring 3 x pendant lights already purchased to be put in pre existing light points. See photos for more information. Photos of the three pendant lights are the ones to be swapped.

Remove unit from outside a shop on Smith Street Fitzroy.

I have 2 Panasonic split systems that are displaying F90 power factor correction protection fault. Require these errrors to be fixed, and a basic service of all 3 split systems. Note: tenants unable to find isolator. Only an internal switch that turns the unit off/on. May need to power cycle at the switchboard.

Small job just need some powerpoints changed to new ones and 4 plugs for downlights put in ceiling space, No plaster on walls and all equipment is here. Job in Fitzroy

We need to position an access point in the middle of the office. Need to supply and install conduit up wall and across support beam and then run Cat5 cable through conduit. We have a 30m supply of Cat5 on suit, but this will need to be terminated by you at appropriate length.

Remove a couple of old garden lights that been mounted on the ground to shine on a small Zen stone garden display. Also remove the wirings connected to them. Should an easy job, in Fitzroy.​ Job does have to be done today, asap. As an electrician has cancelled.

We have three lights in our entrance that do not currently turn on. Haven’t worked since we moved in a year or so ago, just never got around to fixing them. Need some sparky assistance to get them up and running.

Install a ceiling fan, install 3 pendulum lamp shades, install doorbell and pantry light.

Installation of 2 light fixtures required on high ~3.5m ceiling. Both light fixtures made of glass, 120cm long and weigh less than 3kg each (see picture). Includes removal of existing light fixtures (picture also included)