Find trusted local electricians in Fitzroy North

I have two LED down lights that are hardwired into a 4m ceiling (I have a ladder). I need the lights replaced. I also have a long electrical cord that needs to be cut and shortened

2 PowerPoint installed in office cabling is already to the point

Replace 12 x LED Downlights (add plug base). There are 12 LED in place (6 in lounge room, 2 hallway, 4 bedroom). I have bought Philips colour controlled IC4 to replace those. Current lights are wired to a connector. New lights have a plug and will be required to fit to plug base (these will be supplied).

Need an electrician to change some light bulbs (see pictures) and try to fix heater in drying cupboard, and empty a filter of clothes dryer. Lights bulbs - see picture of new bulbs that I already have, you may need to supply the rest (and be reimbursed), in particular the long fluro light. Will need to bring long ladder for lights in kitchen

We have a smoke alarm attached to the roof which is 5-6 metres high. The battery has gone in the smoke alarm and it keeps beeping. We just need someone with a high ladder to come over and change the battery. It should only take a few minutes to change the battery. It’s just getting a ladder that is high enough to reach the smoke alarm, and open it to find out which battery we need, and then to put a new battery in it. The longest part will be setting up the ladder. all in all, it shouldn’t take longe to do. Maybe 30 mins or 40 minutes maximum.

Help install two hardwired wall lights.

Electric cable of roller door peeled. need a fix

Install Red Smoke Alarm in hallway of home and ensure working properly. The alarm is battery operated.

Installation of a supplied air conditioner. There is an existing unit on the opposite side of the same wall. So all services are located in the right position.

When turning the power on to the hot water unit at the switchboard, it is tripping the power. The element on the unit does not appear to be burnt out.

3 x smoke alarms need batteries + replacing. Also have broken light switches that need fixing if there is time. They are switches with programmable dimmer and have cracks in the middle of the button so the button keeps falling off.

We have 2 x ceiling fans but the previous house owners lost the remotes. We have bought 2 new remotes but existing receivers need to be replaced with the new ones for them to work. Licensed sparkies only.

hi, my dishwasher short circuited yesterday and affected the power in the house. need to inspect to find out the problem.

Need an exhaust fan to be installed in a new bathroom reno. Fan also has light inbuilt

The medallion around the light fitting has become unglued and is now hanging from the ceiling. It has been held by the wiring of the light fitting. I would like to have this medallion secured back onto the ceiling. in the corner of the same room, a portion of the ceiling also needs repairing:

The metal screw that sticks out from the outlet was snapped off by moving furniture along the wall. I've tried to secure the cable in with tape but it disconnects randomly. Are you able to reconnect it so the connection is steady and it will look good enough for the landlord at the end of the lease? Looking for a quote too. Thanks for your help :) Felix

Requiring installation of a new 7.1kw Split system Air conditioning unit. The internal unit bracket has already been hung/installed and the electrical cables/power source has already been installed to where the outdoor unit will be placed. I require someone to hang/secure outdoor unit onto external brick wall, penetrate required size hole through brick wall for plumbing and electrical between internal and external units and connect/carry out plumbing electrical requirements (including exterior isolation switch installation).

Need an electrician (who is also knowledgeable with ARLO security cameras with hub) to do the following: - replace 4 x light bulbs (up high, Will need to bring long ladder) - trouble shoot an Arlo camera issue

Replace oven with another oven (which I will supply). Fits into cavity in the cabinet. Needs to be wired into the supply.

I have a simple light fixture that I need installed. It has a plate that needs to be screwed into ceiling and it also needs to be wired into the existing socket.