Find trusted local electricians in Edgecliff

Adding 3-5 electrical points in office with power already. Need insurance but work already approved

We need help with remove the solar panel from roof, so we could install the new roof. Later we’d like to install them back on the new roof.

Looking for a licensed electrician to attend a commercial shop close to Edgecliff Station today for a site inspection. This task is for a $100 call-out fee only to assess the job and confirm exact requirements. Work required: • Three-phase installation (subject to inspection) • Install 32A outlet in one room The $100 call-out fee will be redeemable and deducted from the total cost if you proceed with the full job. When submitting your offer, please: • Provide your licence number • Confirm availability today • Include an estimated total cost for the full job based on the information provided After inspection and agreement, the remaining balance can be added to the task. Thank you.

Looking for a licensed electrician to install three-phase power in a shop located close to Edgecliff Station. Please let me know if this can be completed over the weekend (Saturday or Sunday) or sometime next week. Need to install a 32A power outlet in one room. There is easy access to the ceiling using a standard ladder. Kindly send your offer including your availability. I’ve attached the current power setup at the premises for reference.

I’m looking for a licensed electrician who is available today to install a 32-amp single-phase power outlet in a shop close to Edgecliff Station.

1) We would like to install 12 power points. So we already have a few power points in the wall but would like to add 12 more. 2) We would also like to add 24 LED ceiling lights. Again, there are already some ceiling lights, but we would like to add 24 more. I’m assuming that both the above tasks can be done in a day i.e. 8 hours. I’m understanding if it takes more hours. Happy to pay $90 per hour for labour and additional for materials. Free and convenient parking is available in the building.

Need a pair of vintage lamps re wired

Looking for an electrician to install two new PowerPoint on the wall in my apartment it’s a rental apartment and I’m paying for it. There is currently power areas on both walls but no power points.

Need a turn coolroom doorbell installed on my front door - no electrics. Just need someone with a drill and a few tools to install the screws - must be a qualified builder - should only 30 mins

I need an electrician to correct a noisy smoke detector asap

The A/C stopped working on my 2010 Lexus RX350, no idea what it could be, fuse or maybe compressor?

I need an Electrician to change 11 old fluorescent light fittings to new LED fittings for my office. I have all new fittings ready to install I also need you to replace 1 downlight that is too high for me to reach (4 meters high) as you would have a ladder with you I anticipate 3-4 hours of work and it must be done tomorrow (Friday) ? Thanks

1.4 m x 0.7 m Acrylic LED lit sign to be mounted against gyproc wall. Supplied power cable (attached to sign) to be connected in roof or within wall power supply

Led oyster light replacement

Looking for a qualified electrician to take a look at this ceiling fan. It is controlled by remote, and the light and fan no longer respond to the remote. We have had issues in the past with the remote receiver on a different fan of the same type.

Bmw is giving error codes electricals but all seems well For e.g Flat tyre but no flat tyre Crank sensor fault but it is also fine Lights etc

outdoor light replaced (i have the replacement light), also looking to have the switch installed closer to the light, currently the switch is located in a cupboard.

Need an electrician to install 14 ceiling lights. We have the LED lights. Just need the electrician and the cable. Straightforward job in a small fully open plan 40 square metre office space. It is a standard height Gyprock ceiling with 2 voids to access the space above the gyprock. Task will take approximately 4 to 5 hours. Happy to pay $90 per hour.

I have a gas stove in a new apartment. I would like to change it for an induction stove however I have been advised that I need to confirm that the power point under the bench is capable of providing the correct current/power. I need someone to confirm whether or not it will work. The appliance to potentially be used is the Miele KM7679 induction. Link: https://shop.miele.com.au/en/kitchen/cooktops-and-combisets/induction-cooktops/km-7679-fl-induction-cooktop-zid11554200/ Change: it’s now clear that the power point needs to be changed. I have uploaded more photos to show the switchboard and distance from stove. I’ve also increased the budget. Task is now to change the power point so it is suitable to power the induction stove.

Telstra came out to set up internet (we just renovated apartment) but said that the phone socket was: 1) Not Meeting the NBN needs and ACMA guidelines. Power was needed adjacent to the telephone socket. Not Safe for Telstra to run cables across doorway under the carpet 2) Telstra tested the socket connection as per the TDR results (in photo)showing it is open at 27ft. The first part just means that phone socket needs to be moved closer to power outlet however I don’t understand what the second part means and if this is something that needs to be fixed? Can someone advise honestly and quote for job. I checked with NBN and the unit is connected to the NBN network