Find experienced local tradies in Richmond Tweed

I need a Aluminium Balustrade with gate in patio

The bracket of a roller blind has been pulled out twice due to winding the blind up and down. The holes that the bracket screws into have become large and have started to crumble. We would like to reinforce that part of the drywall so that the screws can stay in place.

Installation of fan light in bathroom and one powerpoint in laundry, can be flexible but looking to have completed ASAP. Wiring already in place. Fan light and PowerPoint supplied

folding arm electric awning not fully housing back into cassette, fabric appears to be rolling onto one side more than the other

I need a awning installed on my 4x4

We have patched areas where screws have penetrated the verandah ceiling - i require someone to attend site, sand and paint the area - the customer has a small tin of paint onsite - there are about 20

We have recently replaced our light fixtures and need 4 holes in the celling to be plastered

Three electrical installs: 1. Ceiling fan where there was a light fitting. 2. Replace faulty light switch. 3. Install new power point in hollow wall with ceiling access. I have the fan and the two switches.

Need a small roof supplied installed for a small sauna roughly 2m x 1.5m

Hang five pictures (lightweight) on gyprock wall and assemble kogan tv stand.

Move sauna - approx 400kg forward about 1 mtr then paint the back of the sauna in cabbots clear stain (water based) -supplied. Also seal the join between the back and front wall to the outside edge with clear / translucent sealant. No damage to deck please when moving.

Need a gyprocker to seal a hole (approx 600mm x 600mm, but no bigger than 1000mm x 1000mm) that were opened up to fix some plumbing in the ceiling of our apartment. Firesafe 13mm gyprock. The batons are already there etc as well.

Damaged Side Of Balcony Balustrade – Replacement Needed Looking for a handyman or carpenter to replace a damaged section of my balcony balustrade. Scope of work: • Inspect the damaged area • Source matching or suitable replacement materials (material costs covered on top of Airtasker payment) • Replace the damaged section • Ensure installation is safe, compliant, and secure Budget: Task is set for 1 hour of labour to inspect and advise on job, with flexibility to extend if the job is approved to go ahead Must have experience with similar work and own tools

Hi, need 4 movers with a couple of movers straps to shift sauna forward 1mtr, coat back wall with decking oil (supplied) and silicone the back outside edge between outside wall and back wall. then shift back. Should take an hour

Deliver plasterboard Bron Bay Gyprock center to Mullimbimby 300 cm x 135 cm

Assemble outdoor barrel sauna and cold plunge on concrete slab. Both come in brand new flat packs with instruction manual.

Construct a inferred sauna 850mm W and 1600mm L

I need some help setting up a ReGen8 Quadro - 4 Person Infrared Sauna. I’d like it done this week, you’ll need some basic tools.

Fix automatic awning that has broken

Demolition work including - Removal of plasterboard - Removal of skirting and cornice - Removal of building waste - Prepping for installation of new sheeting Small studio 6x7 area All tools supplied if needed except your personal PPE Skip bin on site Looking at $35 per hour cash Estimated 10 -15 hours work Total budget if need $500