A tradesman with a tool and hat, ready for work, representing a local tradesman near you.
A tradesman with a tool and hat, ready for work, representing a local tradesman near you.

Find experienced local tradies in Quakers Hill

Fill a short form and get free quotes from local tradesmen near you

4.2

Great rating - 4.2/5 (11114+ reviews)

Get a local tradesman near you today

  • Home renovation & repairs
  • Plumbing
  • Electrical
  • Painting
  • Plastering
  • … or anything else
It only takes 2 minutes. And it’s free.
Up to 50% cheaper than franchise dealers
No job too big or small
Free insurance coverage
Secure cashless payments
Same day or next day service at no extra cost

Best rated tradies near me

Recent Tradesman reviews in Quakers Hill

Fanstastic job done by Tajinder. He fixed my old toilet wall like new. Highly recommended!

Patch plasterboard hole

$120

Great job and recommended

Gyprock repairs

$250

Khan was great! He just got on with it and did everything perfectly. Highly recommend him!

Gyprock Installation and repair in my kitchen

$40

Super quick work and a job well done!

Remove and replaster a 58cm x 136cm section of plasterboard wall

$150

Brendon has done a great job for me, fixing ceiling cracks. very polite, on time, responsive and knew what he was doing. Will definitely recommend him and would be hiring him again.

Cracks on ceiling inside and in garage. appears to be gyprocks joints

$2,000

Lin K was efficient and did the job very fast. He even told me a little bit more information to make my house just that bit more safer. I highly recommend him!!

Fix wall power point

$100

What's the average cost of a tradesman in Quakers Hill

$157 - $450

low

$157

median

$299

high

$450

Low, median and high bar chart distribuiton

Average reviews for Tradesman Services in Quakers Hill

based on 37 reviews

4.97

36
1
0
0
0

What is Airtasker?

Post your task

Post your task

Tell us what you need, it's FREE to post.

Review offers

Review offers

Get offers from trusted Taskers and view profiles.

Get it done

Get it done

Choose the right person for your task and get it done.

Now Available
  • Get it done now. Pay later.
  • Repay in 4 fortnightly instalments
  • No interest
  • Available on payments up to $1,500

46+

Tasks successfully completed

3

Average amount of offers per task

13

 mins

Average time to receive offers

Statistics from the most recent tasks on Airtasker over the last 3 years.

Airtasker has over 38 tradies in Quakers Hill, with an average rating of 4.97 stars from 37 reviews. Get in touch with tradies such as Darren B, Milad B, and Sam M today to get a wide variety of Tradesman jobs done.
Don't live in Quakers Hill? We also have tradies available in Marsden Park and Mount Druitt available today.

Recent Tradesman tasks in Quakers Hill

Install 3 awnings for house windows

$700

Blacktown NSW, Australia

24th Jan 2026

Hi, My house in Blacktown has 3 windows that require awnings. The rain is rotting the wood inside. I've attached some photos of the windows and their dimensions: Window 1 is approx 160 cm width and 130 cm height. Window 2 is the same. Window 3 (bathroom) is 80cm width and 110 cm height. Ideally, I'd prefer an aluminium awning with at stainless steel brackets, so it won't rust. Please provide your quotes (without AirTasker fees - we can work something out) of labour and the image/link of the awnings you'll install. Bunnings have them for $149.85 but they're not wide enough and it has plastic brackets, which is cheap and will most likely require replacing soon. Ideally, I'd like this to be done this week if possible.

Fix the pavers that are coming loose

$50

Quakers Hill NSW 2763, Australia

15th Jan 2026

Fix the pavers that are coming loose. Area to be covered as shown in the photo

Want to get fixed two gyprock holes

$50

Blacktown NSW, Australia

11th Jan 2026

Got two holes in the wall of my house The wall is of gyprock

Nice work Very punctual Nice nature

Fix the ceiling fan and move the outdoor power point

$250

Quakers Hill NSW 2763, Australia

6th Jan 2026

The ceiling fan in the bedroom is non functional. I want it to be looked at and uninstall to send it for warranty. Move the outdoor power point to lower position next to the water tank. Thanks

Milad's work was clean and meticulous. Highly recommend.

Render and paint my house front wall and pillar

$2,000

Quakers Hill NSW 2763, Australia

1st Jan 2026

Render and psint my house front wall and pillar

Roof Plastering

$450

Blacktown NSW, Australia

3rd Dec 2025

I’m looking for plasterer or handyman to cut out a 1200 mm × 600 mm section of ceiling plaster where cracks are visible, install two 1000 mm timber studs, and then replace the plasterboard (or reuse the cut-out piece if possible). The job also includes sealing the joins and matching the ceiling paint over the 1200 mm × 600 mm area. This is a perfect job if you have plasterboard off-cuts or timber off cuts from previous projects. The ceiling height is approximately 2500 mm.

Plain and simple, best tradesman I've hired and I've hired over 10 in the past few weeks. Appreciate you mate.

GYPROCKER REQUIRED !

$10

Blacktown NSW, Australia

3rd Dec 2025

Task is as follows I will be supplying materials. I require 1 x Gyprocker to name their day rate. Photos show the job - it is a combination of patch ups and cornices

Gyprocker Required

$10

Blacktown NSW, Australia

1st Dec 2025

Requesting Gyprocker one day Patch up work + cornices photo shows sample of one room as guide, it is one day’s worth of work

Gyprock repair

$200

Blacktown NSW, Australia

22nd Nov 2025

Cut out broken gyprock and replace

Fix skirting issue, fix gyprock issue and painting sbd silicone

$375

Quakers Hill NSW 2763, Australia

17th Nov 2025

We need old silicone to be removed in bathroom, toilet areas and do it properly. Small painting patch. Fix gyprock top coating, finishing and painting. Fix skirting and cover the gaps in one room. All the work may not be showed in the images.

Gyprock a wall

$10

Quakers Hill NSW 2763, Australia

17th Nov 2025

Wall measurement 3m long x 2.7m high & small repair panel see photo

Paint alfresco roof, repair ceiling and wall gyprock sheet

$500

Quakers Hill NSW, Australia

18th Oct 2025

Alfresco roof is to be painted. Gyprock sheet for roof and a wall is broken.

Gyprock wall sailer

$150

Blacktown NSW, Australia

14th Oct 2025

Wall needs to be patched with gyprock. Few spots and painted aswell

Very professional easy going and punctual. If you ever need any repairs or house painting, this is the bloke to get..

TV wall mount and power point install

$10

Quakers Hill NSW, Australia

9th Oct 2025

Looking for below services : Supply and install 1. 75” TV Wall mount +bracket 2. Cable hiding 3. 2 Power points . Existing power points are located at the corners. We would like to have 2 additional power points installed 1behind TV and 1 at the bottom. Can u provide estimate?

Gyprock and paint finish

$500

Blacktown NSW 2148, Australia

25th Sep 2025

To close a door open door space in the wall with Gyprock and then to finish with the paint accordingly

I need to close off a pace with gyprock

$800

Quakers Hill NSW 2763, Australia

18th Sep 2025

I want to close off a pace with gyprock. 2 walls one wall length 440, height $265 and another wall length 200cm height 265 They need to come together to make a right angle and close off a kitchen in my cafe

Need to install new power point in the garage.

$100

Quakers Hill NSW 2763, Australia

7th Sep 2025

Need to install a power point in my garage

I want gyprock wall in garage at one side of wall with storage

$20

Quakers Hill NSW 2763, Australia

4th Sep 2025

I want ziprock at one side of garage wall with some storage options at the top , approximately height 2.3m and length 6.4m

Repair and paint gyprock

$10

Quakers Hill NSW, Australia

30th Aug 2025

Repair and paint ceiling from water damage

Great service Would recommend

Render Garage Walls

$300

Quakers Hill NSW 2763, Australia

29th Jul 2025

I need my garage walls rendered. Picture attached. I need the front of the garage and a bit on the sides till expansion joints on both sides