Find experienced local roofers in Spearwood

Just need to plaster this tiny hole on our roof

Overall roof 3480 mm wide x approx. 1200 mm projection Proposed 1 degree fall away from house; approx. 21 mm fall over 1200 mm PROPOSED CONSTRUCTION • Roof sheeting: Stratco Topdek 700 concealed-fix steel roofing, 0.42 BMT, suitable for a minimum 1 degree roof pitch, in Surfmist or closest available pre-painted COLORBOND finish. Stramit Speed Deck 500 / Speed Deck Ultra, or another engineer/roofer-approved 1 degree-capable equivalent, is acceptable if required. • Gutter: Stratco 115 Quad gutter in Surfmist, continuous across the outer 3480 mm edge. Use concealed/internal brackets where practicable. Provide a subtle longitudinal fall toward the toilet/right-hand end. • Downpipe: one 90 mm diameter round Surfmist downpipe at the toilet/right-hand end, positioned tight to the existing masonry to minimise visual impact. Connect to the existing stormwater system on site; exact connection route and detail to be determined by the installer on site. • Drainage / projection: roof falls away from the house into the continuous outer gutter. Finished projection may extend slightly beyond the nominal 1200 mm to accommodate the fascia/edge and gutter. Gutter fall is independent of the 1 degree roof fall. Roof fall approx. 21 mm over 1200 mm Outer edge drainage 115 Quad gutter; fall toward right-hand/toilet end Result Very shallow roof plane; approx. 21 mm fall reads visually almost flat. DESIGN INTENT A single long, skinny rectangular canopy. Left edge stops at the brick reveal beside the spare-room door; The existing toilet occupies the right-hand 2020 mm portion. The remaining 1460 mm shelters the spare-room entry.

have watertank in position but need it plumbed into the downpipe (which is rectangular so need adapter to 90mm pipe)

One of my downpipe is rusted snd required replacement, this is standard downpipe, with standard single floor length

Reattach gutter, replace rusty gully on tile roof. Investigate and fix leaks around skylight and Evap. Replace broken tiles (approx 5, I have spares). Need a roof over toilet as shown in photos. Currently uncovered. I need a pro, it needs to be done properly.

1. Water damage to Laundry cabinet. Needs silicon Description Water is getting trapped under cabinet and soaking up from floor. 2. Downpipe leaking flows into step and wall : need modification glue / fix the joints downpipe 3. Window locks not lined up - Need new holes drilled

I require a quote to replace the gutters and downpipes on my home by a qualified professional.

Gutter clean gutter clean house 1 story

I have a defender 110 roof in grey wanting changed to black Roof is not attached to car

Clean gutters and downpipes Single storey 3 bedroom house Tin roof with aluminium?? Gutters

Install the colorbond roof just on top of front door. Roof frame already done.

Replace 10 lm of valley gutter and replace 5 broken tiles and re-bed and re-point 52 ridge caps on the roof.

Replace 10 lm of valley gutter. Replace 5 broken tiles

Pest control of roof and roof cavity of house, spray gardens of granny flat

1. Install Roof Insulation (Alfresco Area 5mx4m) Install supplied insulation in the alfresco roof area. Use any leftover material to top up insulation above the glass sliding door/living room. Access via roof space. 2. Replace Existing Gutter (Approx. 5 m Section) Remove and replace around 5 m of existing guttering with a larger-capacity 175 mm Quad gutter with overflow slots, colour Surfmist. Ensure proper fall (>25mm) towards the downpipe and secure all fixings for good drainage. 3. Fix Water Overflow – Alfresco Corner Remove roof sheets as needed to inspect possible water overflow above the alfresco corner. Remove debris and adjust roof sheet as required to prevent further water ingress. Install side-wall flashing all around the brickwork and roof sheets to stop water entering the cavity, then reinstate roof sheets securely. 4. Re-secure Front Elevation Flashing (Behind Front of House) Seal and fix the loose front brick elevation flashing located between the top of the brickwork and the box gutter. Flashing is currently lifting and needs to be re-anchored to prevent wind noise. 5. Investigate and Stop Roof Tapping Noise (Master Bedroom) During strong winds, a tapping noise occurs above the first east-side window in the master bedroom. Lift roof sheets and Anticon insulation to inspect. Add or tighten fixings to battens/joists as needed, and re-secure sheets properly to eliminate the noise. Flexible timing in the next few weeks. I have existing insulation to use. You will need to supply the new gutter and fixings. Have marked the first photo in red with the areas of work required.

Job in Rolleystone, western autstralia. Available all day for cleaning gutters and help assist with a gutter guard installation

Recent rain found roof was leaking, rain water on my ceiling.

Looking for a chippy to cut the current roof back 2m to allow 3 meter drive way- needs to cut it back and build new gable, need to remove concrete columns and build a wall to support. Might need a beam. Come quote please

Roof rack install from box

Down pipe has been detached from gutter. We bought the house like this. There is some rust. We don’t have any electric tools or screws for the job. Can move the solar lights out the way.