Find experienced local roofers in Earlwood

Tile roof need some repairs. This includes: - Remove, replace, dispose 30 tiles (approximately) that have cracked - Remove and replace one dektite around a vent - Remove and replace 2 rusted valleys - Re-bed sections above where valley points meet - Supply and install flexible pointing compound to all ridge caps throughout the roof - Remove and replace cracked lead flushing under a valley and replace with fast flash flashing (2m length)

Roof and guetter inspection and repair.

Roof inspection and repair if necessary.

Find the source of a water leak through the tile roof and rectify. Roof has never leaked prior to this and only occurred during the recent heavy rains.

Inspect areas of the tile roof where rainwater is leaking, identify the source of the leaks, and carry out repairs to ensure all sections are properly sealed

There are 4 points I want to silicone to avoid gutter leaks. I have the silicon gun, silicon and ladder. 3 points are low (a few steps up to ladder) 1 point is a bit higher (2nd photo).

I would like to replace a leaking, rusted downpipe.

Wash roof tiles. Approximate size is 20m by 10m.

Clean and paint tile roof

Concrete slab above front porch: The concrete slab over the front porch has recently been re-rendered with an acrylic render. This needs to be sealed and waterproofed on the top, bottom and sides. Total area is approximately 10 square metres. Clean any loose material off top of slab. Apply primer. Apply 2 coats of membrane paint to seal and waterproof the render. Apply 2 coats of Dulux Weathershield (or similar) in cream, middle strip on sides is mission brown. Lintels and handrail: There are two lintels above the front porch, one lintel above the rear garage door and a steel or wrought iron handrail on the front porch. Sand surface rust with a wire brush or sandpaper. This may require a power tool (hand drill or angle grinder) with wire wheel/brush attachments. Apply rust converter, such as Killrust Rust-Eeter or similar. Apply rust-inhibiting primer, such as Killrust Heavy Duty Primer or similar. Apply 2 coats of Dulux Weathershield (or similar) in mission brown. Lintel under front bedroom window: There is one galvanised iron lintel under the front bedroom window that has never been painted. Apply metal primer. Apply two coats of Dulux Weathershield (or similar) in mission brown. Guttering: The guttering around the house and the rear of the garage is badly stained Colorbond. There are also four downpipes, but these are generally clean. Clean any moss and loose surface dirt. Apply two coats of Dulux Weathershield (or something else appropriate) in mission brown. Eaves: The eaves around the house and the rear of the garage look like they've never been painted. Clean eaves. Apply two coats of Dulux Weathershield (or similar) in off-white, low-sheen finish. Woodwork: The woodwork at the rear of the house is badly weathered. This includes the vertical wood panelling above the sliding glass doors and window, and other framework. Sand back. Apply wood primer. Apply 2 coats of Dulux Weathershield (or similar) in mission brown.

Sagging roof liner in 2012 VW Passat.

Gutter cleaning for 2 story house

Single storey gutter clean

Damaged roof needs fixing old tiles

Install one sheet of metal roofing( kliplock or trim deck) Fascia and gutter

I live on the lower level of an older house and need some level of soundproofing between them. I dont think there is any insulation between the floors and when the occupants and their cats move, its quite loud. I need an inspection and quote for a range of options I might have to increase the soundproofing, balancing cost and quality. I've put a budget of $500 for now because I have no reference point for what this might cost and am willing to pay more for the right service.

Need to water a planter box which I just drilled some holes in to help it drain. It’s about 1m x 0.5m and 0.5 deep X2 coats waterbase epoxy primer. X2 coats solvent base polyurethane

Supply and install a gutter on the fascia of rebuilt balcony, and connect into existing downpipe, approx 8Lm

I need a skilled roofer to help fill a hole in my roof that is approximately the size of two tiles. Unfortunately, I’ve noticed that birds have access to the void, and I’m worried they may have formed a nest. I have spare tiles on hand, so there’s no need to worry about sourcing materials! Requirements - Assess the hole and ensure it’s safe to work on. - Check for any bird nests in the void and remove them if necessary and safe to do so. - Replace the two missing tiles with the spare tiles I have. - Make sure the area is sealed properly to prevent leaks and further bird access. - Remove the metal down pipe and fill the void in the soffit with a piece of wood I have. **Requirements:** - Previous roofing experience is a must. - Ability to provide a brief estimate of time needed to complete the repair. - Must have necessary tools and safety equipment. If you're interested and available to complete this job soon, please reach out with your experience and availability. Looking forward to hearing from you!

3m x 1.5m gable roof, sliding doors, Easy shed to be installed on concrete slab in place of old shed that has been removed.