Find an experienced handyman in Riverton WA

External render has covered over the weep holes on new built house. Need someone to install weep holes in about 60m of cavity wall, above the DPC/ cavity flashing (need to figure out where this is). Max 1.2m centres, drill weep holes and place clear plastic tube in the hole. Need to avoid any damage to render apart from the weeps holes, and leave it clean.

Hi there, our door handle broke see image. Need a handy man to put a new door handle. Will provide a door handle

To pick up a Stratco handimate shed in canning Vale and install in Riverton. Concrete slab is installed already. https://www.stratco.com.au/au/sheds--garages/garden-sheds/handi-mate-garden-sheds/handi-mate-sliding-door/handi-mate-sliding-door-shed-hm4-slate-grey-shmsssdhm4sg/

Roller blind fell down, need it to be put up again

Installation of a bunnings security door on wooden frame

Looking for someone experienced to build a new lean-to patio/side awning down the side of the house as pictured ( AI image , actual area) I would like the new structure similar to the attached example: • Dark/charcoal metal frame • Clear or lightly tinted polycarbonate roofing • Extend across to the fence line • Neat connection to the existing house eaves and existing patio roof • Proper fall and drainage for rainwater • Posts/supports positioned neatly along the fence side where required Looking for someone experienced with patio/awning construction who can advise on the best way to connect the new structure around the existing eaves and patio roof. Please quote for labour and advise whether you can supply the materials or provide a materials list for us to purchase. Length 6.4 x 2.5 approx

I would like a quote for a dog door installed for a medium sized dog in a glass sliding door.

Installation of security door in front of main entrance door on wooden frame. The door is slightly thicker (9mm) so we might need a 2mt wooden piece/slat to be installed on the wall to make the door flush.

Hi looking for someone to fix our new letter box to the ground. Fix it in to the ground so it stays strong and doesn’t fall for heavy wind/rain

I need an electrician to install 2x ceiling fans replacing existing room lights. Ceiling fans are already purchased and ready in box.

Looking for a qualified awning installer, or experienced handyman to inspect, quote, and either repair or replace damaged metal awnings following recent severe weather. Existing Awnings There are two awning sections attached to the house: Left-side awning: Approx. 4.5m total length (split into two sections by a wall) Approx. 1.8m projection/width Right-side awning Approx. 2.3m length Approx. 1.8m projection/width Corrugated metal roof sheeting. Supported by steel frame members and several long metal support arms/brackets fixed back to the house. Attached beneath the plaster ceiling/verandah area. Damage Observed: (Please refer to attached photos.) Scope Required: Advise whether repair is practical and cost-effective. Provide quote for: Repair option (if feasible), and/or full replacement Supply and install replacement materials if required Remove and dispose of all damaged materials. Ensure awning is securely fixed and suitable for long-term outdoor use. Preferred Replacement: Metal roofing materials preferred. Looking for a durable, low-maintenance solution that will last for many years. Please provide: Photos of similar work completed (if available). Whether you can provide both repair and replacement pricing.

Install metal post in ground. Put metal letterbox on top of post. Repeat for second letterbox.

2 internal doors supply and install with hardware. 1 external door supply install with hardware. 3 existing internal doors with new hardware. 1 external door redundancy with new door latch.

Full render of an external wall (27sqm) with a texture finish. Please ensure colours match: Main Render – Solver Dewkist 150%, Contrasting Render – Solver Dundee. Wall preparation and finish to be neat and consistent with existing render.

Provide and install doggy door on glass door

Hi I'm about to purchase a shed from bunnings and need help assembling it. Here is the product: Absco Sheds 3.0 x 1.52 x 2.08m Monument Space Saver Double Door Garden Shed https://www.bunnings.com.au/applinks_p0079540?source=product_share&utm_source=bunnings&utm_medium=retail-app&utm_campaign=product_share&utm_content=pdp_deeplink

Remove existing electric roller shutter

Install a wall bracket to mount a dryer above my washing machine in the laundry room

I need someone to fix a sliding door (with fly net). It doesn't slide anymore

I need to install a cat flap door on a small size fixed glass panel, the glass panel has the measurements of 600mm by 600mm, the glass is a standard float glass probably with 3mm thickness. I have already purchased the flap door, rough location of the door is shown on the picture attached This is installation only