Find experienced local fencing contractors in Bentleigh

I have a brick fence with 4 timber panels. The brick has recently been rendered, and now the panels need to be reattached to the brick posts. Each panel needs to be secured with 2 screws on each side (4 screws per panel) into the brick posts. What’s required: * Drill suitable for brick * Screws and wall plugs * Experience with fence or basic handyman work Should be a quick job for someone with the right tools.

Want to put up eyelet screws and proper wire to train jasmine up colorbond fence. Please supply materials and do job.

Pictures attached. Digging and installing a new fence post (new post supplied). Securing and fitting/cutting the post in place. Reattaching the existing fence section between the new post and the existing one. All materials are provided – you just need to bring your own tools.

1.8m high timber fence. One part is wobbling and requires new fence post

Looking for supply and installation of aluminium blade custom panel? 2700 gap with about 900 high? To close off alfresco area

Need a new frameless spa fence

Require an additional colorbond paneling installed above a side gate, measurements are approx 210xm wide by 70cm high.

Looking for a 12m fence with a 3.5m to 4m sliding electric gate and a side gate to the front entrance of the house. Either looking at pvc fencing or aluminium slats.

Need a fencing/gate specialist. Want 1 treated pine post cemented into the ground to be the end post or a fence. Need a metal post cemented into the ground alongside what will be the track for a sliding gate. I have the metal post. Holes need to be dug. I can purchase the timber post before job.

I want to construct 12.5 metres of 1.2 metre high front fence, one 9.5 metres long with in-built leterbox, the other 3 metres long at a right angle to the 9.5 metre long section. I want to replicate the example in this picture. The rebuild of the house will soon be complete, so I would like the fence to go in straight after that. I also need a paling fence (12-15 metres in length) and gate at the rear of the build.

We removed a section of fence to build a house. I need that fence panel rebuilt Timber is required.

Columbine fence install, removal of old wooden fence and disposal. New fence 15.5m * 1.8m

Timber fence needs 4 fence posts replaced that have rotted at the base. New posts are to be concreted in. The replacement of the posts will enable the fence to stand up straight again.

Six hard wood fence posts on my side need replacing. Fence is appox. 2 metres high. Ground is Clay. Access is available down side of house.

Part of me fence needs to be replaced.

Removed timber fence approx 45 m and remove all fencing timber and rubbish from site leaving clean for new fence to be erected

Timber Fence to connect missing section. 1.9m high. Approx 7m in length

Fence is pulling away at the bottom, need it pushed back in and nailed in.

To install a wooden front fence. The same as my neighbour . I need the fence to be 1.6 metres high.

We had 2 crossovers installed for 2 townhouses. The council let us know that minimum 400mm of asphalt needs to be reinstated for both crossovers. I have attached photos of the current crossovers and how the asphalt needs to look (this is a photo from the council and shows the minimum 400mm required).