Find trusted local electricians in South East Melbourne

Description: Need a licensed electrician to replace 5 existing button-style lights with new downlights on the ground level. 14 upstairs ✅ You must supply and provide the downlights ✅ They need to be exact match / same style as the photos ✅ Work must be done safely and meet Australian electrical standards 📍 Location: Doveton, VIC 📅 Flexible timing – let me know your availability Please confirm: • You are a licensed electrician • Price includes supply of matching downlights + installation

I need some PowerPoints put in and connected

Hi, In need of a licensed electrician to change the exisiting downlights in my house. There are 18 downlights to replace. The current ones are old and no suppliers have them. I have attached photos. Please reach out if you are happy to help! Thanks

Timberflame Radius (IB35ETR and IB35R) Gas Heater - would like a gas safety check and need electrical wiring connected which I think is somewhere underneath house.

Water leaking From solar panel. Hot water system turned off.

Need an electrician urgently to conduct the following fixes: 1: Fix range hood bulb. I bought a new bulb but it flickers inside the range hood so might have some problem with the range hood wiring. 2: Hob switch needs replacing as it won’t switch to off position. 3: Lamp came off in bedroom that was nailed into the ceiling, need help putting it back in.

I want to upgrade the electrical service line from my main switch board to the fuse outside from 6mm to 16mm.

Need electrician to Fix two loose electric switches. The switches have become loose and become infunctional and cannot turn them on or off.

Remove and replace five (5) existing fixed ceiling light fittings with Uno 250mm Flush Mounted Light Fittings at the existing locations, utilising the existing electrical wiring. No relocation of fittings or extension of wiring is required. Replacement light fittings will be provided by the owner, as well as the globes. The property has standard ceiling heights with straightforward access to all light fitting locations. All works are to be completed by a licensed electrician in accordance with the relevant Australian Standards and AS/NZS 3000 Wiring Rules, including testing of all fittings upon completion and removal of all waste from site.

Need new PowerPoint in hallway Needed to power up and hang LED light on mirror See pics

We have some electical works need to be done. Please kindly provide your quote. Property 1: Change two ceiling lights: We bought two new ceiling lights and we would like to replace the old ones. Property 2: Fix two downlights: Two downlights in the living room are not working. We would like to have them fixed. Both properties are in Cranbourne West, 3 km between them (roughly 5-6 mins driving). We would prefer any time between 8th - 12th July. Thank you so much.

Replaced tubes but still not working. Need to check conncection and fix

Three kitchen downlights tied to the same switch are pulsing. They will need to be replaced with new ones and changed to individual transformer (as opposed to connected)… if that makes sense.

Due to weather electrical sensor light got detached from the fascia board and is hanging down. Also some water got into the fitting and is short-circuiting if you switch it on. Need to reattach the fitting, drain the fitting and make it work

Need a 20amp power point installed in a warehouse

The alarms being replaced are Quell Q1275 240V AC interconnectable. Happy to purchase new mains powered alarms but will need help with remounting and wiring them (the old 3 pin plug on the existing ones have been discontinued)

I am redoing the ceiling in the living room. Need an electrician to remove and install lights and air vents once ceiling is done .

Rebooking task between Tony and Tom

Replace the current ceiling light with a bigger Philips down light

I have a Ring camera that's been installed at home but the battery has died and I need to install a Ring solar panel to keep it charged. Will require ladder access and power tool to drill the panel mount into the wall.