Find trusted local electricians in Northcote

Hello, I require the power disconnected from this power point and capped off to make safe. Please quote. Thank you, Angela

I have a 2009 Holden Colorado LTR Dual cab. I have purchased a light bar and reverse camera I would like installed. The car has already got the switch fitted for the lightbar, the previous owner had the lights taken off but left the wiring. I also have an Android head unit and would like a reverse camera installed.

Outdoor water pump is blowing the fuse so we turned it off. It needs fixing. 2 down lights outside that are broken/need fixing/replacing

Installation of two lights I have everything ready to go including light instructions You will need to remove old lights and replace with new ones

Electrical job to replace a wired in downlight

***Location is in Northcote, Airtasker had an error code when trying to add correct location. 1 ceiling light in loungeroom and intercom also located in loungeroom area is currently off. I believe it’s a loose wire issue as suggested by brother in law that is an electrician but unavailable today as the light has been turning on & off for a few years now but we’ve just tolerated it but now light won’t turn on at all and the intercom has gone with it. Light globe has already been replaced. Would like someone to attend asap please. Thanks in advance, Cathy

I need to move a cable plug about 30-50cm from where it is, to add a new PowerPoint where an old one was, and add power to mount a wall tv.

Create/move 8 GPO’s and move 2 light switches. Full accesss available

Pilot light won’t stay on when I let go of the ignition button. Also leaking around knob for water pipe

Need a skylight installed onto the roof of business. Acrylic skylight sheet is already installed in ceiling, but when roof was replaced years ago, the skylight opening outside was not redone, it was just roofed over.

The cable to the leg of my standing desk has frayed due to bending while relocating. I need the cable to be cut, stripped and safely reconnected. Unsure of cost, open to all offers. Please ask questions if any further information is required.

Initial safety and compliance tests have been undertaken for Gas, Electricity and smoke detector. Biennial checks needed for gas and electrical compliance and annual check for the smoke detector. Only gas appliance is the stove.

New light fitting installed to existing wiring but dimmer switch not activating

Need an electrician to remove this fluorescent light in the kitchen and replace with a kitchen pendant. I haven’t sourced the pendant yet - looking for ideas don’t want to spend too much on the pendant. Can someone please help

External shutter on upstairs window was removed and then refitted when we had our weatherboards replaced. We've since discovered two problems: 1) The frame of the shutter has been put back higher than it should be, this stops us from opening the window 2) The roller is stuck in the closed position and will not open. I can hear the motor trying but there's no movement. The external window/shutter is located on the first floor of a townhouse, access via ladder. Note roof is tiled so caution is required.

Qualified electrician required to install three pendant lights over kitchen bench. Removal of old pendant lights is required.

Wanting oven out ASAP. wanting kitchen clear before Monday. Oven currently hardwired on own breaker, just wanting wires given a plug end so I can demo the kitchen.

I'm getting my house ready for sale, and need some light electrical work. I have about 8 downlights that need to be replaced (I have the new SAL downlights). I have some dimmers in a wall switch that I need to replace with switches (the lights aren't dimmable) Time permitting, I have installed LED strips in my carport, but need a 12V supply for them, and a switch so someone at ground level can turn the lights on/off. I would estimate 1/2 day work, but if you have the day free, there are other small handyman type tasks I could use help with

Require a licensed electrician to simply "cap off" to code (eg wire nuts and electrical box in wall) 2 existing string/cable lights (believe they're 12v, but not 100% sure... Refer photos) being completely removed. Good access. We'll do the plaster repair where required. Shouldn't take long. The place is being painted this weekend, so will need this done on Friday. Thanks in advance for taking the time to put in an offer... Can't imagine this will take more than an hour... We have plaster cutting tools and a fibreglass ladder on-site as the place is mid renovation. Please provide proof of electrical licence.

Need to install aircon unit. The space is has hole and wiring done (isolator installed). I will supply the new aircon which is kogan 2.6kw unit. If you have outdoor wall bracket. That's plus point otherwise we can put it on the floor. Need to get it done asap