Find trusted local electricians in Hornsby

I have a Rhino Rack roof rack and want the kings 300w folding solar installed, I have the brackets just dont have the time to install it. https://www.4wdsupacentre.com.au/300w-folding-solar-panel.html

Repair LED TUBE LIGHT for kitchen

Job Description ​Looking for a licensed electrician to remove an old Commax intercom system and install a new Arlo Video Doorbell at a double-story home. ​The old system consists of two internal stations (one on the ground floor, one on the top floor) and an external doorbell/camera unit. We are moving completely to the Arlo ecosystem. ​Tasks Required: ​Disconnect & Safely Isolate: Disconnect and safely isolate the power/low-voltage wiring for the two old Commax internal monitors (ground floor and top floor) and the old outdoor bell. ​Remove & Clean Up: Remove the hardware. Push the old wiring back into the wall cavities safely. ​Wall Plates / Patching: Install blank white wall plates over the two internal wall holes where the old monitors sat so it looks clean and neat. ​Arlo Doorbell Installation: Install the new Arlo Video Doorbell at the front door.

I want 6.5 KWh Solar Panels insllaed at my place in Hornsby

Looking for a licensed electrician to install lighting in our back garden and install a new pool light. We currently have one outdoor power source located approx. 1.5m from the pool edge, and would like power run from this point to install around 5 outdoor garden lights. We also need a new pool light installed. We are unsure if the existing wiring to the pool light is working, so this will need to be checked and made operational if required. The pool is currently drained, so access is easy. Location: Hornsby Flexible with timing over the next few weeks. Please include license details and a rough quote.

We have a single pool light that currently is not working. We need an electrician to come and change the light fixture and get it working again. It looks like it might not have been working for a while. Our pool is currently drained for access. The wiring will need to be investigated.

Move PowerPoint inside the acoustic box. ASAP Address: 18 ethel street, hornsby

Disconnect oven(hardwired) , switch off power for demo and create a Power point switch where the light switch is. Oven is already isolated as per the board

Licensed electrician needed – underground cable + power points + lighting (Hornsby) Looking for a licensed electrician to help complete electrical setup for a new shed. Location: Hornsby, NSW Scope of work: - Run two underground conduit cables (~15 metres each) from the house electricity box to a new shed - Trench is already dug for most of the run (may require a small amount of additional trenching depending on your advice - labour available onsite if needed) - Install 2 internal power points inside the shed - Install 1 external power point - Install 1 internal shed light with switch - Install 1 external shed light with switch - Set up wiring so the external shed light can also be switched from the house (reason for the second conduit run) Materials: - Conduit, cables, power points, lights and switches will be supplied. - If additional materials are required, we are happy to reimburse. Access: - Easy access to the site - Happy to assist with labour if helpful Timing: - Ideally this weekend - Otherwise early next week during the week Please confirm: - You are a licensed electrician - Your availability - Approximate quote or hourly rate Happy to send photos of the trench and shed if helpful.

Looking for a licensed electrician to replace 4 light switches: • Replace 2 existing dimmers with new dimmers • Replace 2 existing 1-gang switches with new switch + dimmer units All wiring already in place. No new circuits required. I will supply all new dimmers and switches. Licensed electrician only. Please include licence number in your offer.

Building a 4m high wall to wall off a loft that overlooks the living room. Have a quote for someone to build a wall with a door. Want a quote for installation of a light switch on the door and two power points. There's currently a light in the room with a switch near where the new switch will be but it's outside where the room will be. Attached photos are the loft where the wall will go.

No scammers please. I need L2 Mains/meterbox upgrade and electricals done as described in the image by licenced electrician for the entire house. I need electrical done by licenced electrician for a house getting renovated in Hornsby. I had already hired one electrician from facebook marketplace. He started work and cabling was done but now he is blocking my calls after getting most of the money. I need this done asap.

Hello this point point is loose and not secured to wall. Can you please assist repair or replace it. I am not sure how to do it myself thank you

We have three ceiling fans/lights we need installed in three bedrooms. Each spot where the fan is to be installed will replace where a current downlight/ceiling light is located.

Ac in my car is not working.

Aircon repair at hornsby apartment. The aircon itself is working but it isn’t blowing any hot air. It needs to be repaired.

Hi, I need a licensed electrician to relocate an existing power point about 10cm to the side. Details: Plasterboard wall Same wall, same circuit No new power point required Just moving the existing outlet slightly Easy access, no brick or concrete This is a simple job and should take under 1 hour. Please quote including call-out, labour, materials and GST. Thanks.

General Electrical Repairs & Maintenance Require Fully Licensed and Insured Electrician for the followings: * supply and replace down lights (photo shows from current light to the bottom light style). X 4 * Fix the lighting issue master bath bathroom & laundry might be some wiring issue as light in laundry got turn on if bathroom light is on. * exhaust fan repair (about a year old stop working)

Rental property to install a Split aircon system

Outdoor power point stopped working. It's near the pool, on a separate circuit. The fuse is still on. Power point has 2 plugs, both don't work. Power point is not directly exposed to water or rain.