Find trusted local electricians in Turramurra

* Reinstall 3 power points (already have existing locations) * Connect oven (3-phase –) * Install 1 new power point behind the oven

Need a licensed electrician to inspect why the hot water circuit trips and why the NBN power appears to be off. Need a licensed electrician to inspect why the hot water circuit trips and why the NBN power appears to be off. The property previously had two air-conditioning units removed, and the associated electrical circuits were intentionally disconnected inside swithboard as those units were not reinstalled. Please inspect the switchboard and wiring to determine whether the hot water or NBN issues are related. The disconnected air-conditioning circuits should remain disconnected.

Has some people in yesterday to trim a tree. They loosened the power line to the front of the house and when they put it back some of the wires are now hanging down.

Old one fell out need to swap with new one

Need alarm sensors changed and tested Need smoke detectors checked and changed if best Need garage wall remote covered with correct plate -works Need front gate electrical reinstated- works but wire detached

I have a catch control device that needs to be installed for a solar system in the house.

Need a current solar how water heater replaced with and electric heat pump

Three LED mirrors to be installed in bathroom

​Task Description: Hi there, I need a licensed electrician to investigate and fix a wiring issue involving two bathrooms and laundry room. ​The Issue: Currently, the wiring logic is incorrect. When I turn on the light/fan switch in Bathroom 1, it activates the exhaust fan in Bathroom 2 and laundry room. ​Requirements: ​Identify and trace the wiring between the two bathrooms and laundry room. ​Rewire the switches so that each bathroom and laundry switch controls its own respective light and exhaust fan. ​Ensure all work is compliant with safety standards. Must be licensed.

The fountain pump needs to be changed , a waterproof wire connector would be needed

We have the panel and cable connector required, but it will require the right sized screw driver to remove exisiting wall panel.

I have the nbn box and telstra modem, but dont know where to connect it all in my unit. There are ethernet ports in each room as well

Would like loose electrical capped off and a new power point installed a metre from existing see black cross

5 Fans speed controller board to be replaced

My kitchen has a Fisher & Paykel rangehood HC90DCXB1 which is broken. I'm planning to buy a replacement HC90DCXB4. I want someone to remove the existing one and install the new one. The new one should fit into the existing space

The existing electrical cables in my attic are a mess. I'd like them replaced/rerouted and made tidy, compliant and safe before roof insulation and some storage covers are laid. The cables should be three core to allow wifi light switches (require a neutral) to be used in the rooms. The attic is truss, late 90's construction, 6x6m, no insulation, empty and clean (see photo). It sits over a door entry and 6 rooms - a hallway, two bedrooms, bathroom, restroom and small study. The existing cables power ceiling lights, fans, smoke alarms, and security devices. There are some larger cables which supply the rest of the house, one of which which needs re-routing.

Relocate NBN cable to existing private pole and down to the ground and to the inside of the house, no digging involved, just cabling

- Install Ceiling fan - Rewire Pool Light Transformer under house - Fix outdoor GPO - Install outdoor ceiling lights.

Uninstall and replace 5x driveway lights (I've already bought the light fittings). Reconnect circuit to have all backyard lights and fan surrounding pool area turn on/off from one of four switches on four-point switch (inside kitchen area). Inspect and 3x fix dim/flickering down lights in dining room / kitchen area (from the same four point switch).

Dining and bathroom lights are working