Find trusted local electricians in Concord

Need a light removed and another installed

Looking for electrician move switch 72cm

I'm looking for a licensed electrician to install simple outdoor lighting in a new pergola, as well as one external power point on the wall. Details: Pergola will be newly built (by a carpenter) Lighting doesn’t need to be anything fancy – just a cost-effective solution for evening use One outdoor power point to be installed in a nearby wall Property is in Concord, 2137 Timing is still to be confirmed but I’m looking to lock in someone who’s happy to coordinate around the builder’s schedule Please let me know your availability, estimated cost (including materials if possible), and any questions you may have. Thanks so much!

Need an electrician for Electrical layout/ RCP

Assessment and quote for feasibility and cost for running a new circuit to power a pottery kiln/oven on a residential property. Details on the product spec sheet: Phase 1, Volts 240, Amps 33.4, Watts 8000.

I need the existing 3 in 1 heater a shown in the photo to be replaced with a Martec Profile Plus 4 as shown in the link. The existing switch can be used. The existing cut out I measured 335mm x 335mm. For the new one the cut out is 435mm x 275mm. I just need the installation. I can get the unit. https://www.martecaustralia.com.au/product/proile-plus-4-3-in-1-bathroom-heater-with-exhaust-fan-and-4-led-lights/

A ceiling light fixture has short circuited and the tripper knocked off. The light fixture has to be resolved.

Realign solar panels on 2nd story roof. The mounting beams are installed correctly and parallel to roof line. The panels themselves need to be adjusted so that they are also parallel with roof line.

I need to replace my key switches on a limited edition Deathadder essential, there fore I need someone to desolder and , reolace with new key switches and put it back together with no damage

Split type aircon need to be installed on ground floor, house Fujitsu airstage model

Install LED Ceiling light in kitchen

Installation of 2.5kw Fujitsu air condition split system

Powerpoints and electrical wires to be either reconnected/connected and reviewed in a garage/man cave at this property.

We need a new ceiling fan with light fitting in our bedroom. It will require support and may need additional wiring due to the age of the house. Images show the fan, the existing switch and the location of the existing light where the fan is to be mounted. The fan is remote controlled. Please provide a quote for the work thanks

Replace and install 4 Lights ( 3 Pendant lights + 1 Up and Down light )

Need to install a new double GPO on a wall. Have an existing power point nearby. Not sure if there is stud there or not. See photo

Need a qualified electrician to install an outdoor power point in my verandah.

The electrical cord needs replacing as it has totally frayed

I need an a phone line installed. I have purchased a new home and have been advised that I have fibre to the curb. I need a phone line installed from the street. Looks like there is a drawer wire left by the electrician. I need this done asap please. I will be on site tomorrow morning at 7.00am or afternoon at 4.30pm

I have a light bar from Kings that requires to be installed to my roof rack. Harness is provided and I will require to go complete full harness and wire to lights including a switch point internally inside of my car. I also have 2x small lights to be installed rear of car. Extra reverse lights Job scope - Install & supply of any parts required to roof rack