Find experienced local carpenters in Glen Huntly

I have another carpentry job in Glen huntly which needs to be done asap. Needs few doors supplied And installed with new door hardware Bed 2: - 2030 x 760 Bath: - 2000 x 685 Bed1: - 2030 x 760 Main Door - 2070 x 805 - ⁠build dram to close a drywall Need door and hardware installed at this apartment. Can be done straightaway too.

Location: Glen Huntly Cabinets: already assembled with feet attached, except 1 sink cabinet and 1 laundry high cabinet Timing: ideally between 22-24/06 Scope of work: - install cabinets in the kitchen and in laundry - install bulkhead above overhead cabinets in both kitchen and laundry - drill holes at the back of cabinet where electrical powerpoint will be installed by sparky (7 holes in total) - install integrated dishwasher (Bosch series 4 fully integrated dishwasher supplied) - install cabinet doors and handles - modify 1 laundry upper cabinet to be shorter (so that washing machine and dryer can fit below) - modify kitchen tall pantry to fit 3 drawers (3 drawers supplied, tall pantry only comes with 2 drawers originally) - install lazy Susan in corner cabinet please see photo 1 and 2 for current kitchen and laundry, see photo 3 for kitchen plan, and photo 4 for laundry plan. (Note both kitchen and laundry photos are taken with wide angle lens)

We need a bathroom vanity approx. 750 cm wide X 40cm deep full length to floor with either drawers or doors with shelving to suit existing plumbing. Photos of position and plumbing available. Finish is WENGE laminate and we have the new basin and mixer tap already.

Please quote your hourly rate and comment how many hours roughly it’d take Note: bathroom will be demo’d down to bare studs by the time you start, current photo still shows plasters - move bathroom door and door frame horizontally by about 200mm (it’s a non load bearing wall and electrical wires has been moved out of the way) - build shower niche - ensure bathroom studs are plumb and levelled for plastering - change 1 door swing direction (current door is a typical hinged door, it swings left, need to change it to swing right)

Looking for someone to remove wood panels and skirting pieces from two old cupboards. Cupboards are already dismantled — just need the leftover wood and trim taken away. * Easy access * No hazardous materials * Quick job Please confirm availability. It should only take 30 minutes

We got a new sink, and the cupbard door was removed to install the sink. It no longer fits! I need someone to reattach the door by drilling new holes into the cabinetry (the door and the cupboard) so that the door works well again. The photos show that the hinge needs to be moved down about 10cm on both the door and cupboard so that it will fit beneath the sink.

Looking for an experienced Kitchen and Cabinet Maker to work in our factory for 2x weeks (full days) assisting with CNC, Edgebander and Assembly. Must have their own tools. We're located in Glen Huntly / Caulfield South and it may become a full time job depending on work performance.

Need to make a cabinet to close the gas meter.

I have some left over cladding boards from my renovation + some cabinet doors I would like taken away

I've started to strip the window architrave but I'm realising I need help.most of the paint has come off but not all.

Build a cabinet box as extension in an empty space below my kitchen cabinet. See photos. Dimensions approx: part 1: under the oven: W88xD28xH19 part 2 under the sink W127xD27xH19 Price to be agreed on per your quote offered. Happy to go with a quote that is reasonable and will do a good job. Thank you.

We needed to replace an induction cooktop, and the new model doesn't fit into the existing hole in our stainless steel benchtop. We urgently need the existing hole widened by approx 15mm so the installation can go ahead. Images are: - cooktop hole in the benchtop (~90cm wide) - cross section of the benchtop - induction cooktop sitting in the hole showing the issue - close up showing that approx 15mm needs to be cut

Looking for someone to sand it and then stain our small deck (304x352cm). We would like to retain the current colour, but have it consistent rather than patchy as it is now. Can you please provide your own tools and include the cost of the oil/stain in your quite. Timing is flexible. Thank you

Need to fixed a benchtop

I’m looking for somebody to install this recessed mirrored cupboard in my bathroom. Existing mirror will need to be removed and new cabinet into timber studs assuming they can take the weight. (17kg). Please send through your quote if you’ve completed similar tasks before.

Need to create timber slanted box that prevents climbing. It’s shaped like a very large wedge roughly 50cm by 50cm at the base. I can supply materials, ie the timber. And you just need to cut it and secure the pieces. But you need to tell me what timber to buy. It needs to hold weight of a child about 30kg. It’s an easy job but I just don’t have the tools to do it. - Due date: Before Thursday, 23 November 2023

We are wanting to replace existing sink area with a sink counter bench either stone, or laminate bench top. Need shelving space under, a wash up and handwash basin and space for dishwasher under. The current space is shown in picture. Length 1900 Depth 650-700 Need completed on the weekend before the Melbourne Cup. - Due date: Needs to be done on Saturday, 4 November 2023

A piece of wood under my fascia board fell off and a new piece needs to be put on - Due date: Before Thursday, 20 July 2023

I have 5 book shelves that I’d like to add an arch top to. Bookcase will be assembled and attached to the wall. The arch is needed to be cut and added to the bookshelf and I’ll paint. Builder will need to buy the mdf Please see the photos of the bookcase and the added arch I’d like. Would like to add the height of the arch around 1/2 a metre maybe ? Price is not real, as id like to know what I am working with your offers for this type of job. - Due date: Flexible

Pantry broke and has fallen out of the cupboard it was fitted into. Wanting reinstallation of pantry door (supplied but needs hinges re-fixed on both pantry and door) and needing a new pantry created. Mostly interested in shelves and maybe a few different draws, but will need discussion. Attached images of the pantry once fallen out - not wanting to replace the internals but gives an idea of the door. Likely a two part job (one to assess the work and one to complete). - Due date: Flexible