Book a professional blind repair service in Sydney

Remover the bathroom mirror, then reinstall a new one H86xW50cm. Install a standard roller blind.

Need roller blinds put up/drilled in

Looking for someone experienced with roller blind repairs. The beaded pull chain on my roller blind appears to have shifted/misaligned. The small beads on the chain may have moved out of position or slipped in the clutch/gear mechanism, causing the blind to not operate properly. I believe it may need the chain to be realigned/reset in the roller mechanism, or replaced if necessary. Looking for someone who can: * Inspect the roller blind and beaded chain mechanism * Realign/reset the chain and clutch mechanism * Make sure the blind opens and closes smoothly again Please bring suitable tools and any common roller blind chain parts if possible.

The metal chain in my roller blind has snapped. Needs to be replaced at fixed to window again.

Please - remove 3 roller blinds from windows in one unit. - Remove one set of vertical blinds in 2nd unit - Install one of these roller blinds in another unit (same building) Install a sheer curtain at another window in same unit.

We need to get a blackout blind installed in our bedroom, within an apartment. We have a cavity built into the ceiling, where the housing of the blind needs to sit.

Replace single roller blinds to double for both living room and bedroom windows.

Need blinds hung on two windows. Components all available

Install Quickfit s fold curtains 2 rooms 4 metre width 3 metre drop - room 1 2.6 metre width 2.7 metre drop - room 2 https://www.quickfitblindsandcurtains.com.au/how-to-hang-s-fold-and-wave-top-curtains.html

Large roller blind is stuck when rolling up

Remove 2 sets of curtains and 2 roller blinds and install 4 new Roman blinds (from Tuiss/Blinds online). Dispose of old curtains if possible! If it was today (Friday 31st) before 3pm that would be amazing, otherwise Monday 3rd August Must have own tools (including masonry drill bit) and ladder and experience installing blinds

I purchased recess fit double roller blinds from DIY blinds but the original airtasker I had do the install ran into an issue with hitting a thick metal lintel in the frame and he wasn't equipped to handle. Looking for someone with specific experience ideally in blinds/drilling through metal to help with installation. There are 2 sets of double roller blinds: - Sliding door (~2m) - Window (70cm)

Description: The mounting bracket on one side of my roller blind has come away while lowering the blind with the chain, leaving the blind hanging on one side. I’m looking for someone to: * Reattach and securely support the existing roller blind. * Ensure it is properly aligned and operating smoothly. * Supply and fit a replacement bracket or fixings only if required to resecure the existing blind. Please note: I am not looking to replace the roller blind. The blind itself is in good condition and only needs to be reattached and supported. Photos of the issue have been attached. Please bring any standard brackets, screws or fixings that may be required.

Vertical blinds cord reconnected to the weights at bottom of blinds or New cord on

Hi, just need two 150 cm roller blinds hung in my living room. I have already purchased the blinds. I think it should be quite a simple job.

Roller blind has come off its track - not sure what happened (might have pulled too hard) but the chain has come off. I can see there’s a guard on. Not sure if that’s the right term. A ladder is needed because it’s quite high up. See pictures for a clearer understanding. The last picture is how it is supposed to look like.

2 x 2500 5 x 900 roller blinds

Unfortunately, I started this task myself but couldn’t finish it because I can’t do it when my baby is asleep or when she’s awake as I have to be with her. I already took measurements and managed to drill a hole (brick). Just a standard blind from Bunnings. Thanks

I need a blackout blind installed in my bedroom window however, I’m in a rental so if there’s something I can take down or have removed when I move out with minimal damage/disruption that would be ideal, can someone please advise if they can assist? I can get actual dimensions next week but roughly speaking 2.4x3m I can buy materials if you can link me something or source them yourself and can talk through additional pricing 🙏🏼

Just need a drill and to drill into a wall to hang a light bamboo blind. Shown in the picture is an identical but slightly smaller blind.The blind that needs measures roughly 140 x 120