Find a reliable appliance technician in Ringwood North

Just a water leak from the valve connected to the dishwasher under the kitchen sink.

Hooking up the washing machine, need the hose too

We can no longer operate the dishwasher. The power button causes all lights to flash on one and then switch off. No other buttons do anything. Our model is Haier HDW13V1S1

Electrician needing help to remove and install 90cm oven. Just need a second helping hand for about 20 - 30 minutes. Potentially if you like can come to. Second job doing the same thing around 10am - 2pm time to be finalised on the day For tomorrow 30 July only

Hills hoist doesn't go up or down. It rotates

Dishwasher fault – Miele F11 (Drain Error) The dishwasher is displaying F11 and is not draining properly. Please check- Drain pump and impeller for blockage or damage. Drain hose for internal blockage. Sink drain connection/spigot for obstruction. Drain pump operation and output

Gas Heater Repair Needed Today – Ringwood North Need an experienced gas heater technician today in Ringwood North. My gas heater lights up, but the flame/burner won’t stay on and keeps shutting off. Might be an issue with the thermocouple, pilot light, or gas valve. Looking for someone with experience in gas heater repairs (licensed preferred). Please send your availability and quote. Need it fixed ASAP. Thanks.

Smeg oven makes a loud screeching noise when in fan forced mode, and when the temperature is turned up. May require new convection fan motor assembly, but needs to be diagnosed. Looking for an experienced Smeg oven repairer to diagnose and perform repairs in one visit. Price quoted is for diagnosis and repair labour only, with parts additional depending on what's required. Tasker will be selected based on total estimate including replacement of fan motor assembly (if required).

A sink connected to hot and cold water and to the drain Hot water system installed Gas line extended and connected to the equipment fryer stove and kebab machines Open to offers

The treadmill is not turning on , nothing of note occurred believe it may be the circuit board.

Hisense washing machine cracked seal needs replacing. I do not have the part

I need a basic service of a ride on mower - airfilter, plugs etc

A sink connected and a gas line extension

Dishwasher won’t turn on seems to not have power have turn off tried to reset and still won’t work

We want to move existing kitchen cabinets to make space for adding in a dishwasher and want to know if this is possible and cost of doing the same Not sure what this will cost so will put a minimum number for now as I would like a quote

Somehow my Bosch dishwasher stopped working and kept displaying ‘check water’. I tried to clean the hose as well as all the equipment within, but it’s still not working.

MIELE DISHWASHER 4 years old won’t start after a power serge all other power is working Model hg07

I think a the fuse has blown in my Janome overlocker. Model 434d. Worked perfectly and then suddenly wouldnt turn on. Saw a quick falsh. It was a very hot day and we had power running high with aicon etc

I am planning to install a dishwasher, but currently, there is no space. This job requires modifying the cabinets first. Looking for someone who can take care of the whole job (modify cabinets, install the powerpoint and plumbing works). However, happy to take quotes for just modifying the cabinets.

I need a qualified and experienced tradesperson (stone mason / cabinet maker / benchtop installer) to trim an existing kitchen benchtop so an induction cooktop can be properly fitted. The benchtop is a stone / engineered stone surface (see attached photos). The current cut-out needs to be adjusted. Scope of works: Carefully trim the internal cut-out of the benchtop Each internal corner needs to be cut square to approximately 90° Approximately 20mm needs to be removed from the front internal edge of the cut-out Cut must be neat, precise and suitable for installing an induction cooktop Avoid chipping or cracking the benchtop Final opening must be clean and fit-ready for appliance installation Additional details: Benchtop is already installed Cooktop and cabinetry are in place (see photos) Power is accessible Work is internal and at bench height Please bring appropriate stone cutting tools and dust control Photos: Please refer to the attached photos which clearly show the existing cut-out, corners, and area requiring trimming.