Find a reliable appliance technician in HMAS Kuttabul

Looking for a licensed plumber quote to install plumbing and waste for a washing machine in my apartment in Potts Point. The washing machine is currently only sitting in the lounge room and is not connected to any plumbing. Scope of work: Extend existing kitchen water supply and waste plumbing. Run the plumbing through the wall from the kitchen area into the lounge room. Position the washing machine on the right-hand side of the fireplace. Install the required washing machine water connection and waste outlet. Advise on the best concealed route before cabinetry/joinery is installed. Ensure the work is suitable for an older apartment building. Photos and floor plan can be provided. Licensed and insured plumber only please. Location: Potts Point NSW

Install washing machine - plumb into wall ( we have machine and laundry). 2 girls in twenties that don’t know their doing 😂 $50 max

URGENT – Commercial Oven Technician Needed Today Looking for an experienced technician or electrician to install a new Tecnodom commercial oven arriving today at our restaurant in Potts Point, Sydney. Must have experience with commercial kitchen equipment and preferably 3-phase ovens. Need someone able to connect, test, and ensure everything is running correctly. Please message with your experience, availability today, and installation price. Potential ongoing hospitality equipment work available.

Hi, I’m looking for someone experienced with Fisher & Paykel DishDrawer dishwashers to diagnose and repair my current unit. Model: Fisher & Paykel DD60SDFX9 Product code: 81215-C Serial: NHG279757 Issue: the dishwasher is not draining properly. There is standing water at the bottom, and when powered on it makes a very loud whirring/fan-like noise. I’ve already cleaned and checked the filter/pump area multiple times and can’t see any obvious blockage. Possible issue seems to be either: * blocked drain path / hose / sink connection * jammed or failed drain pump / rotor / impeller * possible flood sensor / leak fault state I’m looking for someone who can: 1. Diagnose the issue properly 2. Check the drain hose, sink connection and pump/rotor area 3. Confirm whether it needs a drain pump/rotor replacement or another part 4. Repair it if possible, ideally on the same visit if parts are available Please only offer if you have experience with Fisher & Paykel DishDrawers or similar dishwasher repairs. It would be great if you can mention whether you can source parts, and your availability. Location: Kings Cross, Sydney Timing: as soon as possible / flexible

My built-in Miele dishwasher is showing F78 error and not running properly. I have already: cleaned the filter checked for visible blockages inspected accessible pump area reset power The dishwasher appears clean and drains normally, so I suspect: stuck/seized circulation pump from inactivity or circulation pump issue Looking for someone experienced with Miele dishwashers to: diagnose the issue attempt repair if possible advise whether repair or replacement is more economical Location: Woolloomooloo NSW 2011 Please let me know: your experience with Miele repairs estimated call-out fee availability whether parts can be sourced if required

Disconnect and remove existing washing machine Install a Fisher & Paykel single drawer dishwasher in the same location Connect dishwasher to existing plumbing and waste Existing setup. Hot and cold water connections located under sink Waste currently connects to sink trap (spigot) Flexible hose connections (not rigid pipe)

Need NG oven hooked up - need correct hose attachment

I need to replace an existing hardwired oven and slide-out range hood with new units of the same size

We need a plumber to remove old tap-ware and install new mixer tap on bench (not wall) and single sink. And plumbing to install a new dishwasher. Dishwasher will be installed by builder where we currently have drawers (see photo) needs to be plumbed in.

Assess whether the current freestanding dishwasher can be replaced with built in under bench

Hook up new winterhalter UC s machine for small restaurant.

Fisher & Paykel single-drawer DishDrawer is stuck resuming an Eco cycle and won’t start a new one. Details: • Machine powers on normally. • Constant fan noise when it turns on. • Cannot change cycle from Eco. • Holding Start does not cancel the cycle. • Power cycling at the wall does not reset it. • There was standing water in the sump area (filter has been cleaned). • It does not appear to be fully draining. • No obvious external leaks. Looking for someone experienced with Fisher & Paykel DishDrawer models specifically. Likely issue: drain pump blockage/failure or possible flood sensor triggered. Would like diagnosis and repair.

The filter is broken but I cannot get it out to clean it. I think it is stuck.

Our fridge/freezer has been leaking water every couple of days with huge ice build up in the fridge. We have defrosted twice and put back together keeps reoccurring.

The Start/Pause button on my Euromaid WM5 front loader washing machine has sunk into the panel and can no longer be pressed. The button appears to have physically collapsed inward — the internal switch cannot be reached. Everything else on the machine works fine (power, program selection, display). It just needs the Start/Pause button repaired or replaced so the machine can be started again.

I can order and pay for the panels from Sydney doors, however, I need someone to install and provide guidance as to how to make sure best, seamless integration. The current carcass that the fridge sits within wasn’t intended for an integrated appliance. I want to workshop this.

E4 error flashing on 2 out of 3 induction cooktop areas. Brand is Smeg

Oven isn't working, keeps tripping the breaker. Still functions in the microwave mode but not in oven mode for more than 5 minutes. Can be fixed either this afternoon Monday 19 Jan or Tuesday 20 Jan.

Oven does not appear to be heating. I have recently purchased the house. It is an ikea oven lights up but does not heat

Remove dryer from apartment. What you do with the dryer is up to you. Definitely a two person job.