Hire a trusted gas stove repair and installation service in NSW

Ideally someone who can come today is preferred.

quote for a Gas cooktop installation in a granite bench top. I am still trying to purchase a gas cooktop to fit the existing cutout. Some cutting of the benchtop may be needed.

We would like to replace the 60cm 4 burner gas cooktop, with the new one. Dispose the old one. Due to regulation need to be installed by licensed to install gas cooktop and an invoice

Hi My gas meter is broken, and it’s very expensive to repair, so I’m considering replacing my gas cooktop with an electric one. My oven is already electric, and the cooktop is the only appliance that uses gas. There is also a power point right next to the cooktop.

I bought a 90cm ASKO gas stove. The hole in my bench is slightly too small, some stone needs to be cut and possibly a little timber. Also need to connect the gas. Hole dimensions 83.5cm x 47.5cm Stove base dimensions: 85cm x 47.6cm

Installation of New cooktop replace with old one. 60cm stainless steel 4 burner gas top.

Job: Gas cooktop burner repair – Belmore NSW Looking for an experienced licensed gasfitter to repair one burner on my gas cooktop. The problem: - The burner lights while I hold the knob down, but the flame goes out as soon as I let go. - The white ceramic igniter pin next to the burner looks worn/eroded. I think the thermocouple (flame failure device) and/or the igniter needs replacing, but happy for you to diagnose. Cooktop brand/model: Technika Thanks

My gas stove is operating at very weak flame, I only discovered that there is regulator attached to cooktop and another regulator which was connected in kitchen cupboard too. I need the internal regulator to be removed from cooktop

Repair minor chip on 60cm gas cooktop

## Licensed Gas Fitter Needed – Gas Cooktop Installation (Kogarah, NSW) I’m looking for a **licensed gas fitter with a valid NSW licence** to help install a new gas cooktop at my house in Kogarah. **Please do not apply if you do not hold the appropriate NSW gas-fitting licence.** **Preferred date:** Saturday, 17 October 2026, during the day after 12pm. **Parking:** Driveway parking available. ### Scope of Work 1. **Remove existing gas cooktop** – I can assist with removal and disposal. 2. **Install new gas cooktop** – Electrolux 60cm Natural Gas Ceramic Cooktop (Model: EHG635BE), already purchased. 3. **Enlarge existing benchtop cut-out** – The benchtop is laminate, and the existing cut-out needs to be enlarged slightly to accommodate the new cooktop. - New cut-out width: 560 mm - New cut-out depth: 490 mm I’m a qualified carpenter and can assist with the benchtop modification using a jigsaw and circular saw, if appropriate. 4. **Connect and safety-test the cooktop** – Complete the gas connection, installation and required safety testing. Existing gas and electrical outlets are available below the cooktop. ### About the Job I’m a qualified carpenter and happy to assist with suitable preparation and other tasks to help get the job done efficiently. **I don’t think the job will take too long**, especially as I can help with the removal and benchtop modification. All gas-fitting work must be completed by an appropriately licensed professional. Please get in touch if you hold the required NSW licence and are available on the preferred date. When responding, please confirm your licence, availability and quote for the job. Thank you!

The spring in the bathroom sink plug is no longer releasing. I pushed it down, but it is now unable to pop back up. The cooktop ignition is also not turning on, although the gas is still working.

Removing a 60cm electric oven, 60cm gas cooktop and 60cm recirculated range hood and replacing with new appliances.

LICENSED Gas plumber needed to 1. remove gas cooktop / block gas pipe but leave gas meter. Cap off. 2. remove / block gas heater bayonet from wall behind sofa. Cap off Apartment in surry hills 2010, car park access, elevator. Gas meter etc is under kitchen sink opposite to cooktop Gas cooktop connection is next to oven Would like this done Tuesday 25 Aug or Wed 26 Aug - time flexibe

I need a certified plumber to replace my gas cooktop.

I need my induction hob removed and a gas cooker top installed. There is gas underneath. The tops are the same size.

Need to cap off a gas cooktop as I’m installing new induction cooktop.

licensed plumber to install a new gas cooktop. old one has been removed.

disconnect and dispose the old one install new cooktop and test - note oven needs to be temporarily removed old model https://www.miele.com.au/domestic/cooktops-and-combisets-2473.htm?mat=07111200&name=KM_2012 new model Bosch Series 2 Gas cooktop 60 cm Stainless steel PBH6B5K90A PBH6B5K90A

Gas stove , my nephew installed it but I have fear it might leak or not installed properly!! Its a 15 min job so dont send quotes costing hundreds

My cooktop gas jets needed to convert from natural gas to LPG.. can you provide quote for the same. https://lpgjets.com/en-au/collections/bosch/products/bosch-pbp6b5b60-4-burner-gas-hob-lpg-conversion-kit Cooktop models: PPS9A6B91A PCR9A5B90A