Hire a trusted appliance repair service in NSW

My Haier washing machine is still relatively new. It’s a 9kg front load model number is HWF90ANI. It stopped mid cycle and never worked before . We drained the water inside but it still doesn’t work. I need someone to diagnose and fix it.

Dishwasher stopped working with water pooling at bottom. Washing cycle not starting.

The Top spray on SMEG dishwasher needs repair

Fridge is not cooling, freezer is cooling ok, I think it is the fan that transfers cold air from freezer to fridge, the technichian replaced the fan last year , I think it stopped working again.

Fix 2 dryers to ensure running properly, clean out dust & change mould piece

Dryer was making squeaking noises over last 3 days and stopped spinning today.

Looking for a licensed plumber/gas fitter to service a gas fireplace and address a pipe issue. Scope of work: Lopi Gas Heater: Carry out a general service/safety check, and diagnose/fix the decorative lights on the base of the unit that are currently half working. Water Hammer: Investigate and resolve a water hammer issue (banging pipes) that has started occurring since a new gas water heater was recently installed.

Machine keeps pausing depending on the cycle we put it on. It either gives E10 or E40 error.

Dish washer fix Seems something block

My dishwasher has started giving the E4 error and I need someone experienced who can fix this issue.

The clothes dryer starts cycle and stops randomly after a few minutes then I have to press the door at the bottom and it starts but after few minutes it stops again so i need to keep pressing the door and hit start button again and again to keep the cycle going.

Washing Machine is leaking under front door. We suspect the issue is related to the front load seal, which may need to be placed. There appears to be a cut in the seal and after a wash the seal becomes loose and creates tumbling noises and cause obvious leaks because the seal becomes loose during the tumble. Front load Washing machine is a Samsung Bubble wash 8.5kg WW85K54E0UW

The dishwasher is dripping from the very bottom (right hand side). Gasket appears okay.

Our Smeg fully-integrated dishwasher (model DWAFI6314-2) won't stay closed. The plastic door catch/latch has snapped. It's the mechanical catch, not the electrical switch, and the machine is otherwise working fine. IMPORTANT: You must bring the correct replacement part with you on the day. The part is the Smeg door-lock assembly, part 690074493 (this exact part was fitted to this machine before, so it is confirmed). Your quoted price must INCLUDE the cost of the part, not just labour. Payment will only be released once the repair is completed on the day, so please do not book unless you will have the part in hand. If you arrive without the part, we will reschedule and payment will not be released. Looking for someone experienced with appliance/dishwasher repair to supply and fit the replacement door latch. - Please also check the door seal and latch area while you're there, as there's some corrosion up top from water getting into the latch pocket. - It's a fully-integrated unit with a cabinetry front panel, so please take care with the door, decor panel and hinges. - Photos of the rating label, the broken part, and the latch area are attached.

My washing machine is not draining and it needs to be repaired. I believe it might be a clogged hose as the machine is only 2 years old. The machine sits under a dryer so the dryer will have to be lifted off to access the machine. It is for my airbnb property and the guest is arriving today so ideally today or tomorrow would be great.

Gas isn’t coming through to our heater. Need a professional to repair it.

Mr Coffee machine F11 fix maintaince , pressure in machine issue

Need someone to fix my washing machine. Can’t open the bottom to clean it, I’ve tired pliers. It still washes fine

We have a Bosch dishwasher which have started giving error E09. Want someone to come check for a fix and price part replacement if required.

The ilve IVSIX6 dishwasher is displaying E4 error. Water gathers at the bottom where the rubbish filters are when the inlet is turned on. The gathering waters is clean. Water pumps out with no blockage, but is just gathers with clean water again after a few minutes. There's a wooden panel fixed at the bottom of the dishwasher as it is build in the cabinet