Hire trusted appliance installation services in SA

Old smeg has been removed. Existing duct hole. Need to install Schweign isodrive 1650

Like yo like rangehood replacement.

Install new Westinghouse 60cm oven Both electric same size, no need to dispose of the old one

Hi, I’m looking to replace my old 60cm rangehood, as the fan is no longer working. I’m looking for supply and installation of a suitable new rangehood. Please see the attached photos of the existing rangehood and setup. Just a note: the fan is not working. If it can be repaired, that would be fine. Otherwise, I’m looking for a suitable replacement and installation.

I’m looking for qualified tradespeople to remove an existing Rinnai gas heater and replace it with a built-in electric fireplace at my home. The existing gas heater is approximately 910 mm wide × 650 mm high. Photos can be provided. The job would ideally include: -Safe disconnection and capping of the existing gas supply by a licensed gas fitter -Removal and disposal of the existing Rinnai gas heater -Supply and installation of a built-in electric fireplace with realistic flame effect -Any required electrical work/power connection by a licensed electrician -Necessary modification of the existing opening/wall to accommodate the new fireplace -Making good/plastering and neat finishing around the new fireplace -Testing and commissioning of the installation -Relevant compliance certificates for gas/electrical work -I am open to recommendations regarding the brand and model of electric fireplace suitable for the existing space. When quoting, please specify: -Brand and model of the electric fireplace you recommend -Fireplace dimensions and heating capacity -Price of the fireplace -Labour/installation costs -Whether gas disconnection, electrical work, removal/disposal and wall finishing are included -Any items that are not included in your price I am looking for a good-quality, modern electric fireplace rather than a basic electric wall heater. Licensed and insured tradespeople only, please.

Need a licensed appliance technician to install a replacement 240V AquaStop inlet hose on a Bosch Serie 6. Part is already purchased. Invoice required

Install under cabinet range hood. Old range hood has been removed. Ventilation pipe and power point are there. New range hood is on site. We had trouble getting the screws into the range hood and then into the cabinet above as the range hood motor takes up most of the space inside the range hood and the screw holes are in a very awkward position. It is a Mistral MBRS606-5W. If you know how to install this, please do, but we had trouble with the location of the holes and the motor being in the way.

Have removed the rubber seal of the washing machine but can't get it back on...

Remove old rangehood Install new rangehood

See photo attached for installation details

I bought the Halo Doser with sensors for acid and chlorine to work with my Astral Halo chlor and need to have it properly installed.

Replace a chair gas-lift cylinder

Need an electrician to do a simple 54cm Oven Install swap over, swapping a 54cm 5 year old oven for a new one that I have had delivered allready, unhook the old one and hook the new one up.

We need a certified electrician to help us disconnect our current oven and connect the new one

Current rangehood: - Existing unit is a 60cm Westinghouse slide-out rangehood. - Existing unit has failed and needs replacing. Job required: - Remove existing rangehood. - Install new 60cm slide-out rangehood (I will supply the new unit). - Existing ducting will be reused if compatible. - An access hole may need to be cut in the upper shelf/false panel inside the cupboard to access rear mounting screws. - Dispose of old rangehood if possible (please advise if extra cost applies). Unknowns: - I am not yet sure whether the existing unit is plug-in or hard-wired. - I am not yet sure of the duct size (120mm or 150mm). - The installer may need to inspect on site before confirming compatibility. Please let me know: - Your experience with rangehood replacements. - Whether you can handle both installation and any required cabinet access hole. - Whether a licensed electrician would be required if the existing unit turns out to be hard-wired. Budget is flexible depending on site inspection and whether electrical work is required.

I have a hole in my kitchen, probably where the old one use to be? Keen for a new one to be put in. Thanks

Disconnection of built in 60cm oven (8 years old) - it doesn’t have a wall plug, it is wired in and goes to a cabling loom. Install new 60cm oven in place (also hardwired) New oven is Westinghouse WVE6516SD.

Disconnect old electric stove & install new one Description: Looking for a qualified electrician to safely disconnect and remove my existing electric stove, and install a new one in its place. Scope of wor Disconnect and remove old electric stove Install and connect new electric stove Ensure everything is working safely and compliant Dispose of old unit

Install vent cover over th stove

Pick up hotplate from Harvey Norman, Marion Warehouse: 20–22 Butler Boulevard, Adelaide Airport, SA 5950. Model: WHC943BD WEST/HOUSE 90CM 4 ZONE CERAMIC COOKTOP. Removal of old hotplate and installation of new one at Clarendon home.