Hire trusted appliance installation services in West Adelaide

Installation of new rangehood 60cm

We have removed our old 60cm Omega Range Hood! We need our new one installed. Cabinet will need to be cut as per photos to allow new one to be installed. The new one is Bosch 60cm

Installation of a new rangehood and removal of the existing one. Please attend to the job of removing the existing Robinhood rangehood and installing a new Becko rangehood at a ceiling height of 2.7 meters. The flue canopy will also be replaced. An additional cut to fit the flue is required, approximately 1 cm in circumference. The inner duct and workings are reported to be compatible. Exiting: RWBC3F933 NEW BRH90CX

Install gas heater take out old one

I need to get a rangehood installed in my alfresco area. Will need someone to come and have a look

Alfresco rangehood install (ACH12BBQB), Electical already complete, will need to cut through insulated panel for ducting approximately 200-250mm in width and silicone

To install Ranghood with electrical connections, remove the existing one.

Installation of 120cm Euro Alfresco Rangehood under a small ceiling eave in an alfresco area. Above the eave is the back of a garage with colorbond roof (front pictured). Preferably after ducting out above the roof. Eave is approx 43.5cm deep (hopefully just enough) and height from ground is 2.7m (88cm cabinet bench height to be put in which hopefully allows minimum heigh clearance). Looking firstly to confirm this product will be possible to install noting the measurements, and then for someone to install rangehood with ducting and waterproofing on roof. I can assist with any lifting required. Thanks

1. We are moving into new house . For safety reasons the gas heater was removed and kept in garage. Need to reinstall it. 2. Need to fix the drain hose on Washing machine and dish washer

I have a very old house but would like a range hood installed - the kitchen is little and crappy and a lean to basically but I purchased the range hood a couple of years ago and i would like to get it happening

We’re looking for a skilled technician to replace the programming board and vacuum pump in a Cryolipolysis beauty machine. All replacement parts are supplied and the manufacturer has provided detailed video instructions for the installation process.

Installing eufy Security Indoor/Outdoor Complete Security Kit

I have currently a washing machine there, as you can see the photos and their space on the right and left. I need someone with a bit of experience who can supply and install a good quality dryer with the washing machine and utilise the space in a much better way

Purchase and install the exhaust fan - View all the details of this offer: https://www.airtasker.com/offers/01KAJFYQ4JN7PBZFFDEWV879DQ

Supply and install zone controllers with wifi. Service duct system if required.

Remove dish washer and install new dishwasher. Freestanding under bench. No disposal

I need a dual battery and lightbar installed on my 2022 Toyota Hilux Rogue. Will have a fridge/freezer running off the battery. I have the lightbar, bracket to attach to a Rhino rack Platform, switch for the lightbar and switch for a fridge ready to install. Don’t have a battery

I want to install my new dishwasher at my new house.

Install a gate motor. Battery or mains operated, unsure yet.

Require removal and disposal of existing unit and install of new Bellini BGT705X Existing cutout is slightly larger than that required by new, with lip covering gap, so should be relatively straight forward. Perhaps a small wedge/filler would be beneficial. Existing Cutout: 615 x 485 (Chef 121GGW) New cutout: 552 x 470 (Bellini BGT705X) new unit dimensions 680 x 500. Install desired between 6/8 and 10/8 (delivery expected 4/8) For some reason I'm unable to post the link to the model specs without it being moderated, but please google 'Bellini BGT705X' if you wish to review the install instructions. I've attached a picture from the install guide of the existing unit if helpful.