Find an experienced gas fitter in SA

Bbq repairer thinks pipe connecting gas has melted - should have been copper & then it should be good - was working fine one week, next no gas no smell at all of gas

I have an existing outdoor natural-gas connection at my home in Adelaide that was previously used for a BBQ. The current setup has an older flexible braided hose/regulator assembly terminating in a threaded female connection (photos attached). I would like a licensed gas fitter to: * Inspect the existing natural-gas BBQ connection and check for leaks. * Remove/replace the old hose/regulator arrangement as appropriate. * Install an approved natural-gas bayonet outlet/socket suitable for connecting an Australian Weber Q2200 Natural Gas BBQ. * Pressure/leak test the completed installation and ensure it complies with applicable Australian gas-installation requirements. Please quote including parts and labour. Licensed gas fitters only.

Need to disconnect gas line and terminate for old air heater.

Require QUALIFIED plumber / gas fitter only. - Gas-log heater removal. Cap gas connection and remove heater and flue. Happy for flue to remain above roof tiles. - Install new kitchen sink (same dimensions). - Install new laundry tub (same dimensions)and new mixer tap. - Install new under sink water filter and tap. - Install new gas cooktop (same dimensions). - Install new toilet (in existing position).

We have a gas connection at the wall in alfresco. Need to connect barbeque pipe with gas connection.

Looking for an authorised person for gas disconnect

The Ignition Electrode is faulty on my gas top and need to be replaced,

Looking for a gas plumber to cut and cap the gas line to the redundant gas wall furnace

Capping gas pipe line to make line shorter.

Need to fix the pilot of a four burner commercial stove. Need a certified gas fitter.

I need my approximately 15-year-old Westinghouse freestanding gas cooker inspected. The ignition clicks continuously with every burner knob fully off, and two burner electrodes are sparking simultaneously. The issue originally affected one burner and has progressed to two. I have turned the gas off. The gas isolation valve appears to be separate from the cooker. The model number has rubbed off. There has been no unusual spill or moisture; the cooker is used for normal daily cooking and wiped with a dry cloth. The gas oven has no other noticed problems; the issue is limited to the clicking and sparking.

Siemens 90cm gas hob model ER9A6SD70A one spark plug broken and wont ignite. And other two burner takes longer to ignite.

Photo attached. Kitchen renovation needing the gas pipe cut back and capped. Will require some excavation of the brick wall (double brick with cavity) Then capping with 15mm bpress gas cap + testing the gas line with just a couple photos of holding pressure. Don't need the wall patched. I'm a plumber just in Melbourne and can't get to it in time for the cabinet maker. Would appreciate the help on this one. It's in Hilton an empty house.

The flame of the gas burner is very small, need to be adjust and cleaner

Need to disconnect a gas line from a cooker, there is no isolation valve so it will need to be capped. Range hood to be disconnected from power, im happy to remove it if needed but just need it disconnected.

Gas stove burner not working properly. The burner cap and flame spreader (top pieces) are missing, causing a very low/uneven flame and ignition issues. Igniter broken. Need someone to inspect, supply and fit correct burner cap/ring igniter and ensure proper flame output.

Installing lpg into our takeaway shop. The bottles have already been placed out the back of the shop but we need to run pipes from the bottles to the equipment inside which are 3 fryers, 1 grill and 4 yiros spits. The distance from bottles to equipment is roughly 30 metres . Needing work to be done asap

I’m looking for a licensed gas fitter to inspect and reconnect the gas supply at my newly rented home. The gas has been connected by the supplier, but it was left turned off due to a safety issue identified at the property. I have a notice from the gas distributor explaining the reason for the shut-off (see attached photo)

Need a gas inspection completed on a house prior to settlement

Gas flow/flame is low on stove top. Diagnose issue